![background image](/i/zelmer/157766/zelmer-23z010/h/zelmer-23z010-055.png)
55
TROUBLESHOOTING
Please check the table below before contacting the service center.
Problem
Possible causes
Solution
The appliance doses not operate
after pressing the on/off button
(8).
The water full indicator
(3)
flashes, the water container
is full.
Empty the water container.
Room temperature is higher than the set temperature
(cooling mode).
Reset the temperature.
Not cool enough
The windows or doors in the room are not closed.
Make sure all windows and doors are
closed.
There are heat sources inside the room.
Remove the heat sources if possible.
Exhaust air duct not connected or blocked.
Connect the duct and make sure it
functions properly.
The set temperature is too high.
Decrease the set temperature.
Air filter is blocked by dust.
Clean the filter.
Gurgling sound
The sound comes from the flowing of the refrigerant inside
the air conditioner.
This is a normal situation.
The compressor does not work and
the display shows „P2”
The water container
(D)
is full.
Remove the bottom drain plug and
empty the container.
ATTENTION: If the air conditioner still does not work, immediately unplug the appliance and contact an authorized Arconet service
center.
PERIODIC INSPECTION OF THE APPLIANCE
1. Systematically perform obligatory inspections of the appliance every 10–14 months.
2. Report the appliance for inspection in the authorized service center.
3. The cost of the inspection is covered by the owner of the appliance.
ECOLOGY – ENVIRONMENTAL PROTECTION
Each user can protect the natural environment. It is neither difficult nor expensive.
In order to do it: put the cardboard packing into recycling paper container; put the polyethylene (PE) bags into container for
plastic.
When worn out, dispose the appliance to particular disposal centre, because of the dangerous elements of this appliance,
which can be hazardous for natural environment.
Do not dispose into the domestic waste disposal!!!
The terms and conditions of the warranty are pursuant to the regulations in force in the country the product is sold.
The manufacturer does not accept any liability for any damages resulting from unintended use or inappropriate handling. The manufacturer reserves his rights for modifying
the product any time in order to adjust it to law regulations, norms, directives, or due to construction, trade aesthetic or other reasons, without notifying it in advance.