![background image](/i/zelmer/154230/zelmer-23z050/h/zelmer-23z050-060.png)
60
1. Handle.
2. Mist nozzle.
3. On/off knob.
4. Humidity level knob.
5. Control lamp.
6. Water tank.
7. Base.
Names of parts
Operating instructions
On/off knob (3)
Turn the knob
(3)
clockwise 1 time to the
COOL
position for Ultrasonic (cool mist)
mode.
Turn the knob
(3)
clockwise one more time to the
WARM
position for warm mist (hybrid
humidifying) mode. Set the knob
(3)
in the
OFF
position to turn off the appliance.
Humidity level knob (4)
Turn the humidity level knob
(4)
clockwise or counter-clockwise to set the desired mist
volume.
LOW
–
HIGH
.
Control lamp (5)
The control lamp
(5)
illuminates red to indicate that there is no water in the humidifier.
In that case the appliance will not operate. Fill the tank with water for the appliance to
restart, the control lamp
(5)
will illuminate green again.
Preparing for operation
1. Remove the water tank
(6)
from the appliance using the attached handle.
2. Remove the mist nozzle
(2)
from the water tank
(6)
.
3. Turn the water tank
(6)
upside down and remove the water tank cap by turning it
counter-clockwise.
NOTE: The Nano-Silver water filter is attached to the water tank cap. If you do
not wish to use the filter, it can be removed by turning it counter-clockwise (see