![background image](/i/zelmer/153834/zelmer-bs2500/h/zelmer-bs2500-027.png)
27
BS2500-001_v03
Use and operation
BEFORE FIRST USE
1
Unpack the appliance.
2
Insert the right type of batteries into the battery
compartment (see “Changing Batteries”).
3
Set the required measurement unit using selection switch
(3)
(see “Measurement Unit Selection”).
4
Set the language of the talking feature using the
language selection switch
(4)
(see “Language Selection”).
5
By turning the volume control knob
(5)
, you may select
the desired sound volume.
USE
1
Place the appliance on a hard, level surface. Do not use
your scale on carpets or any other flexible surfaces.
2
Place your foot on the scale and press down.
3
Wait until the display shows „ ”.
4
Stand still on the scale with both feet and wait for your
measurement to appear on the display and blink once.
5
The speaker informs you about the weight twice in
a given language.
6
When you step off the scale, it will turn off automatically
after 15 seconds of inactivity.
If you want to use the scale again, reset the
previous value by pressing the appliance with
your foot and waiting for the display to show
„ ” value.
ALERT MESSAGES
Change batteries
– the display will show „ ” and the
appliance will turn off automatically after a few seconds.
Overload indicator
– the display will show „
”. Remove
any load to prevent the scale from damaging.
When using the appliance, do not exceed the
maximum permitted load of 150 kg.
Weighing error
– the display will show „ ”. Repeat the
weighing.
Function description
AUTOMATIC SHUT OFF
The appliance will shut off automatically after about 20
seconds of inactivity.
UNITS OF MEASUREMENT SELECTION
The appliance is equipped with a function for selection of
units of measurement.
If you want to change the units, move the switch
(3)
(situated
on the bottom side of the scale) to the desired position.
LANGUAGE SELECTION
The appliance is equipped with a voice function. The weighed
value is read out in a given language.
If you want to select the desired language, move the switch
(4)
(situated on the bottom side of the scale) to the desired
position.