![background image](/i/zelmer/151706/zelmer-zzw-6031xe/h/zelmer-zzw-6031xe-123.png)
123
ZW-004_v02
SIZE AND INSTALLATION OF THE UNIT
1
The wooden unit should be constructed according to Figure
3
below.
The unit should be constructed according to the given measurements.
The overall weight of the unit should not exceed 4.5 kg.
2
Attach the hook to the wooden unit and guide it into the hole in the outside door of
the dishwasher (see Figure
4a
). After positioning the unit, install it on the outside door by
means of bolts and screws (see Figure
4b
).
Installation of the unit.
The hook is lifted from position 1 to the appropriate place then pushed right to the
position 2, making the panel and the outer door align.
Installation of the wooden unit.
REGULATION OF DOOR SPRING TENSION
Door springs have default tension for outside door. If the wooden unit is installed, it is
necessary to adjust the tension of the outside door anew. Turn the regulating bolt to
tighten/loosen the steel cable (see Figure
5
).
Door spring tension is right, when the door are in a horizontal position when fully open, and
lift for closing by a slight move of a finger.
Regulation of door spring tension.
5
loosen
3
4a
Outer door
4b
bolts
plate
distancing pad
fastening for
the unit
unit door
bolts
the outside door
of the dishwasher
1. Remove the plate.
2. Screw the bolt in.
3. Put the pad back on.