5

Operation 

♦

  Plug power cord into a grounded electrical outlet. Turn the power switch on rear of unit 

to the "ON" position.   

♦

  The machine will begin producing foam as soon as it is turned on. To stop the foam, 

turn the power switch to the “OFF” position.

Important: Always monitor tank fluid level during operation. 

Running a foam machine without fluid can permanently damage the unit.

 
If you experience low output, mechanical noise or no output at all, unplug immediately. 
Check fluid level, the external fuse, remote connection, and power from the wall. If all of 
the above appears to be O.K., plug the unit in again. If you are unable to determine the 
cause of the problem, do not simply continue pushing the remote button, as this may 
damage the unit. Return the machine to your ANTARI dealer. 

 
Maintenance 

Do not allow foam liquid to become contaminated. Always replace the caps on the liquid 
container and the snow machine liquid tank immediately after filling. 
Before storing, flush out system with clean water. 
 

Foam Liquid 

Fill with ANTARI Foam Liquid or other dealer-recommended high-quality water-based 
snow or foam fluid. Any other types of fluid can damage the unit. 

Save these instructions.