Care and maintanence

Detergent dispensing drawer

Clean when necessary:

1. Open the drawer as far as possible.

2.  Push down the depression on the suction cup and pull the drawer 
out completely.
3.  Clean  the  drawer  under  warm  running  water.  Pull  off  the  suction 
cup; Clean
suction cup and opening in the drawer with warm running water, 
pierce the opening with a needle if necessary. Replace the suction 
cap.
4. Wipe off detergent residue from the drawer guides. If present, 
remove calc deposits from the water-jet nozzles (inside the drawer).

Foreign matter trap

• Clean the foreign matter trap at least once after every 30 wash 

cycles I

• Clean foreign object trap, if foreign objects (coins, buttons, baby 

socks,
etc.) are blocking the suds pump.
• Drain left-over water before cleaning (see below).

(o

___________ 1 M N

Water intake fiiter

At the end of the water intake connection module and water inlet 
hose-tap side, there exists filters. These filters prevent any dirt and 
objects passing into the machine. It is advisable that these filters 
should be cleaned every 30-40 washes. To clean the filter, first turn 
the tap off. Then, disconnect the hose and clean the filter with a 
thin brush. If the filter is very dirty, you may clean it by pulling out 
with pliers. To clean the filter at the tap side of the hose, pull it out 
by hand and clean the filter under the tap water.

Hose

To prevent any leakage, have a technician to control the hoses 
every two years. If the machine is placed at cold ambient 
temperatures, the water remining inside the pump and hoses should 
be removed from the filters. Also to prevent freezing, empty the 
water intake hoses by disconnecting from taps.

Drum

Do not leave any metal objects (pins, needles, etc.) inside the 
drum. These objects may cause rust on the drum surface. Do not 
clean the drum with scratching elements.

15