Connection
19
Connecting an S-Video source device
Examine your Video source device to determine if it has an unused S-Video output socket
available:
•
If so, you can continue with this procedure.
•
If not, you will need to reassess which method you can use to connect to the device.
To connect the projector to an S-Video source device
1.
Take an appropriate S-Video cable (not supplied) and connect one end to the S-Video
output socket of the Video source device.
2.
Connect the other end of the S-Video cable to the S-VIDEO socket on the projector.
The final connection path should be like that shown in the following diagram:
• If the selected video image is not displayed after the projector is turned on and the correct
video source has been selected, check that the Video source device is turned on and
operating correctly. Also check that the signal cables have been connected correctly.
• If you have already made a Component Video connection between the projector and this S-
Video source device using Component Video connections, you need not connect to this
device using an S-Video connection as this makes an unnecessary second connection of
poorer picture quality. See
"Connecting Video source devices" on page 17
for details.
A/V device
S-Video cable
