Using the projector
23
did not record the password in this manual, and you absolutely do not remember it, you can
use the password recall procedure.
To enter the password recall procedure
Press and hold the
4
Right button for 5 seconds. The projector will display a coded number
on the screen. Seek help from the local BenQ service center to decode the number. You may
be required to provide proof of purchase documentation to verify that you are an authorized
user of the projector.
To change the password
1.
Open the on-screen menu and go to
Setting > Change Password.
2.
Press the
3
Left or
4
Right button. A “Change Password” message displays.
3.
Enter the old password.
•
If the password is correct, you can go on to enter new password.
IMPORTANT: Write your selected password down here in this manual so that it is available to
you should you ever forget it.
Password: __ __ __ __
Keep this manual in a safe place.
•
If the password is incorrect, a “Password Error” message displays. Press the
5
Up
button to try again or press the
6
Downbutton to cancel.
4.
Check the new password.
5.
You have the following options:
•
Press the AUTO button to complete the procedure.
•
Press the
5
Up button to try again.
•
Press the
6
Down button to cancel the set-up and return to the on-screen menu.
Adjusting the height
The projector is equipped with one quick-release adjuster foot and one rear adjuster foot.
These adjusters change the image height and projection angle. To adjust the projector:
To retract the foot, hold up the projector while pressing the front adjuster button, then
slowly lower the projector. Screw the rear adjuster foot in a reverse direction.
If the screen and the projector are not perpendicular to each other, the projected image
becomes vertically trapezoidal. To correct this situation, adjust the value of Keystone in the
Picture menu, on the projector control panel, or on the remote control.
1.
Lift the projector up and press the
adjuster button to release the
adjuster. The adjuster will drop into
position and be locked.
Do not look into the lens while the lamp is
on. The strong light from the lamp may
cause damage to your eyes.
2.
Screw the rear adjuster foot to fine
tune the horizontal angle.
