Operation
40
Shutting down the projector
1.
Press
Power and a confirmation message
will display prompting you as pictured to the
right.
If you don't respond in a few seconds, the
message will disappear.
2.
Press
Power a second time to turn the
projector off. The Power indicator light flashes
orange, the projection lamp shuts down, and
the fans will continue to run for approximately
90 seconds to cool down the projector.
To protect the lamp, the projector will not respond to
any commands during the cooling process.
3.
Turn the main power switch off.
4.
Disconnect the power cord from the wall socket and the projector.
Do not unplug the power cord before the projector shutdown sequence is complete or during
the 90-second cooling down process.
If the projector is not properly shut down, to protect the lamp, when you attempt to re-start the
projector within hours, the fans will run for a few minutes to cool down. Press Power again to
start the projector after the fans stop.
I
I
