15

BOSCH

* Model dependent

EN

gl

ISH

5. vertical steam



See the leaflet sides

This can be used to remove creases from 

hanging clothes, curtains etc.

1. Set the temperature control (12) to “max”.

2. Hang article of clothing on a clothes hanger.

3. Operate the iron in a vertical position at a 

distance of 10 cm / 4 in, and press the shot of 

steam button 

[ ]

 (2) repeatedly with pauses 

of at least 5 seconds.

6. Ironing without steam



See the leaflet sides

This enables the iron to be used for dry 

ironing.

Set steam regulator (3) to the 

[

] 

position.

DripStop

7. Drip protection *



See the leaflet sides

lf the temperature is set too low, the steam is 

automatically switched off to avoid dripping.

There may be an audible click when this occurs.

8. Spray



See the leaflet sides

This can be used to remove stubborn 

wrinkles.

Do not use the spray function with silk.

secure

9.  “secure” auto shut-off 

function *



See the leaflet sides

The “secure” auto shut-off function switches 

off the iron when it is left unattended, thus 

increasing security and saving energy.

If your iron is equipped with “secure” function, 

you can find the text “auto off” on handle.

1. Plug in the iron.

2. Initial heating up process: this function will 

be inactive for the first two minutes in order 

to give the appliance time to reach the set 

temperature. 

3. The safety circuit will switch the appliance off 

automatically and the pilot light (15*) will start 

flashing in the following cases:

a

 If the iron is not moved for 30 seconds 

while resting on its soleplate or on its side.

b

 If the iron is not moved for 8 minutes while 

in the upright position.

4. To reconnect the iron, just move it about 

gently.

10. “SensorSecure” function *



See the leaflet sides

The “SensorSecure” function makes the iron 

heat up only when the handle is gripped, and 

stop heating when the handle is no longer 

gripped. Thus, safety and saving energy get 

increased.

If your iron is equipped with “SensorSecure” 

function, you can find the text “SensorSecure” on 

handle.

1. Plug in the iron.

2. “SensorSecure” light (16*) flashes when 

the handle is not gripped, and will show a 

continuous light when the handle is gripped.

3. If the iron handle is released for more 

than 10 seconds, the iron will stop heating 

automatically.

4. When the handle is gripped again, the iron will 

start heating up again.

Initial heating up process:

 it is not necessary 

to grip the handle until the iron heats up to the 

set temperature. Once reached such 

temperature, the pilot light (13*) goes off.

11. after ironing



See the leaflet sides

1. Switch the steam regulator (3) from 

[

]

 to 

“max” and back again several times (self- 

cleaning).

2. Empty the tank. Hold the iron with the point 

down and shake lightly.

3. Store standing on the rear, not on the base.

4. Do not wrap the power cord (14) too tight!