Инструкция для DAEWOO DSB-125LH

(скачивание инструкции бесплатно)
Формат файла: PDF
Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.
Дополнительно: Чтение инструкции онлайн
background image

OPERATION TIPS

The following events may occur during normal operation.
1.

Compressor protection
The compressor can't restart for 3 minutes after it stops.

The indoor or outdoor fan stop running when defrosting (Cooling and heating models only).

only

from building material,

Protection of the air conditioner.

Anti-cold air (Cooling and heating models only)

The unit is designed not to blow cold air on HEAT mode, when the indoor heat exchanger is in
one of the following three situations and the set temperature has not been reached.

A) When heating has just starting.

B) Defrosting.
C) Low temperature heating.

Defrosting (Cooling and heating models

)

Frost may be generated on the outdoor unit during heat cycle when outdoor temperature is low
and humidity is high resulting in lower heating efficiency of the air conditioner.
During this condition air conditioner will stop heating operation and start defrosting automatically.
The time to defrost may vary from 4 to 10 minutes according to the outdoor temperature and

the amount of frost buildup on the outdoor unit.

2.

A white mist may generate due to a large temperature difference between air inlet and air outlet

on COOL mode in an indoor environment that has a high relative humidity.

A white mist may generate due to moisture generated from defrosting process when the air

conditioner restarts in HEAT mode operation after defrosting.

3.

You may hear a low hissing sound when the compressor is running or has just stopped running.
This sound is the sound of the refrigerant flowing or coming to a stop.
You can also hear a low "squeak" sound when the compressor is running or has just stopped
running. This is caused by heat expansion and cold contraction of the plastic parts in the unit
when the temperature is changing.

A noise may be heard due to louver restoring to its original position when power is first turned on.

4.

This is a normal condition when the air conditioner has not been used for a long time or during first
use of the unit.

5.

This is caused by the indoor unit giving off smells permeated

from furniture,

or smoke.

A white mist coming out from the indoor unit

Low noise of the air conditioner

Dust is blown out from the indoor unit.

A peculiar smell comes out from the indoor unit.

10

6.

When indoor temperature reaches the temperature setting on air conditioner, the compressor will
stop automatically, and the air conditioner turns to FAN only mode. The compressor will start again
when the indoor temperature rises on COOL mode or falls on HEAT mode (For cooling and heating
models only) to the set point.

The air conditioner turns to FAN only mode from COOL or HEAT (For cooling and

heating models only) mode.

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Оглавление инструкции
  • Страница 1 из 16
    USE'S MANUAL SPLIT-TYPE ROOM AIR CONDITIONER MODEL #: DSB-075LH DSB-095LH DSB-125LH DSB-185LH Please read the operating instructions and safety precautions carefully and thoroughly before installing and operating your room air conditioner. S1
  • Страница 2 из 16
    CONTENTS SAFETY PRECAUTIONS ....................................................................................... 1 PARTS NAMES ..................................................................................................... 4 MANUAL OPERATION
  • Страница 3 из 16
    Safety Precautions To prevent injury to the user or other people and property damage, the following instructions must be followed. Incorrect operation due to ignoring of instructions may cause harm or damage. The seriousness is classified by the following indications. ! WARNING This symbol
  • Страница 4 из 16
    ! CAUTION Do not clean the air conditioner with water. When the air filter is to be removed, do not touch the metal parts of the unit. It may cause an injury. ! ! Do not put a pet or house plant where it will be exposed to direct air flow. Do not clean unit when power is on as it may cause fire and
  • Страница 5 из 16
    Prior to Operation 1. Contact an installation specialist for installation. 2. Make sure the unit is grounded efficiently. 3. Do not use a damaged or non-standard power cord. 4. Do not share the same outlet with other appliances. 5. Do not use an extension cord. 6. Do not start/stop operation by
  • Страница 6 из 16
    PARTS NAMES Indoor unit Indoor unit 2 1 7 4 3 8 10 6 5 SET AUT COO O DRY L HEA T TEM 9 PER ATU 11 RE ( C) FAN HIG MED H LOW TEM P MOD 1. Front panel 2. Air inlet 3. Air filter 4. Air outlet 5. Horizontal air flow grille 6. Vertical air flow louver 7. Display panel 8. Remote controller signal
  • Страница 7 из 16
    MANUAL OPERATION Manul operation can be used temporarily in case you can not find the remote controller or its batteries are exhausted. Open and lift the front panel up to an angle until it remains fixed with a clicking sound. 2 One press of the manual control button will lead to the forced AUTO
  • Страница 8 из 16
    ADJUSTING AIR FLOW DIRECTION Adjust the air flow direction properly otherwise, it might cause discomfort or cause uneven room temperatures. Adjust the horizontal louver using the remote controller. Adjust the vertical louver manually. Adjusting the Vertical Air Flow Direction (up - down) The air
  • Страница 9 из 16
    ! CAUTION The AIR DIRECTION and SWING buttons will be disabled when the air conditioner is not in operation (including when the TIMER ON is set). Do not operate the air conditioner for long periods with the air flow direction set downward in cooling or dry mode. Otherwise, condensation may occur on
  • Страница 10 из 16
    MAINTENANCE WARNING Household Drain Cleaner No It is necessary to stop the air conditioner and disconnect the power supply before cleaning. Cleaning the indoor unit and remote controller CAUTIONS Thinner Use a dry cloth to wipe the indoor unit and remote controller. A cloth dampened with cold water
  • Страница 11 из 16
    4. Remove the Electrostatic Filter from its support frame as shown in the Figure on the left (Not applicable to the units without electrostatic filter). Do not touch this Electrostatic Filter within 10 Electrostatic Filter minutes after opening the inlet grille, it may cause an electric shock.
  • Страница 12 из 16
    OPERATION TIPS The following events may occur during normal operation. 1. Protection of the air conditioner. Compressor protection The compressor can't restart for 3 minutes after it stops. Anti-cold air (Cooling and heating models only) The unit is designed not to blow cold air on HEAT mode, when
  • Страница 13 из 16
    7. Dripping water may generate on the surface of the indoor unit when cooling in a high relatively humidity (relative humidity higher than 80%). Adjust the horizontal louver to the maximum air outlet position and select HIGH fan speed. 8. Heating mode (For cooling and heating models only) The air
  • Страница 14 из 16
    Troubleshooting tips Malfunctions and Solutions Stop the air conditioner immediately if one of the following faults occur. Disconnect the power and contact the nearest customer service center. OPERATION indicator or other indicators flash rapidly(5 times every second) and this flash cannot be fixed
  • Страница 15 из 16
    ABOUT THIS MANUAL
  • Страница 16 из 16