35
Turning Off the Projector
Follow the procedure below to turn off the power of the projector.
PROCEDURE
Turn off the power for the signal sources that are
connected to the projector.
Check that the power for all connected components has been
turned off.
Press the [Power] button.
The following confirmation message will appear.
If you do not want to turn off the power, press any button except
the [Power], [Page down] or [Page up] button.
If you do not press any button, the message will disappear
automatically after seven seconds. (The power will not turn off
at this time.)
Press the [Power] button once more.
The lamp will switch off. The Power indicator will flash orange
and
will start.
The cool-down period lasts for about 20 seconds.
When cool-down is complete, the Power indicator lights
orange.
1
2
Projector
Remote control
CAUTION
If the message "The projector is overheating. Clean or replace the air
filter and lower the room temperature." appears on the screen, press
the [Enter] button on either the projector's control panel to turn the
power off and then clean the air filters.
3
Stops flashing and lights orange
TIP
If the Power indicator is flashing orange, operation of the [Power]
buttons is disabled. Wait until the indicator lights continuously.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
