Мануал: мини грузовик Grillo QUAD DX125s

Каталог инструкций / Производители / Grillo / QUAD DX125s

Инструкция для Grillo QUAD DX125s

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

background image

1

OWNER’S MANUAL

This manual contains important safety information:

read it carefully.

---------------------------------------------------------------------------------------------------------------

NEVER OPERATE THIS ATV IF YOU ARE UNDER AGE 16.

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

24

25

26

27

28

29

30

31

32

33

34

35

36

37

38

Оглавление инструкции

Страница 1 из 39
OWNER’S MANUAL This manual contains important safety information: read it carefully. --------------------------------------------------------------------------------------------------------------- NEVER OPERATE THIS ATV IF YOU ARE UNDER AGE 16. 1
Страница 2 из 39
INTRODUCTION This manual will provide you with a clear understanding of the details and operation of this vehicle. This manual includes all safety information. It provides information necessary to ride your vehicle. It also includes basic service and inspection procedures. AN IMPORTANT SAFETY
Страница 3 из 39
Particularly important information is distinguished in this manual by the following notations: ATTENTION: the Safety Alert Symbol means ATTENTION! BE ALERT! YOUR SAFETY IS INVOLVED! WARNING: failure to follow WARNING instructions could result in severe injury or death to the vehicle operator, a
Страница 4 из 39
IMPORTANT WARNING This vehicle has been projected and built for the off-rode use. The employment on asphalted roads and on roads opened to traffic needs of some precautions. This ATV is in specification with both the noise levels laws and the standards for spark arrested on exhaust box, in force
Страница 5 из 39
CONTENTS: WARNING AND SPECIFICATION LABELS 6. OPERATION To start out and accelerate To decelerate Engine break-in Parking Parking on a slope 2. SECURITY INFORMATIONS 3.DESCRIPTION AND MACHINE IDENTIFICATION Progressive number record Vehicle identification number 7. PERIODIC SERVICE Engine oil Idle
Страница 6 из 39
Front and rear brakes Fuel Engine oil Throttle lever Lights Switches Tires Wear limit of the tires LOCATION OF THE "WARNING AND SPECIFICATION LABELS" 6 2 Read and understand all of the labels on your quad. They contain important informations for safe and proper operation of your quad. In case of
Страница 7 из 39
Never remove any labels from your quad. If a label becomes difficult to read or comes off, a replacement label is available from your dealer.. 3 1 7
Страница 8 из 39
1 - WARNING Some indications which are contained in the 1 and 4 labels, that you find on your vehicle, are refered to the Countries where the ATV is not homologated for the employment on road or for the passenger transport. Even if in italy it is not compulsory, the use of the helmet is advisable.
Страница 9 из 39
SECURITY INFORMATIONS WHEN YOU DRIVE AN ATV YOU MUST BE VERY CAREFUL An ATV reacts differently from the other vehicles, like motocycle and cars. The wrong use may cause rapidly a crash or the tipping, both during the normal manoeuvres and bending or overtaking hills and obstacles. THE
Страница 10 из 39
• Always check your ATV, before using it, to verify its security during the emploi. • Using the ATV, always keep both the hands on the handlebar and the feet on the running boards. • Do not use the ATV in rivers with strong currents or in deeper waters than 25 cm. (10 inch.). • Always use tires of
Страница 11 из 39
DESCRIPTION AND MACHINE IDENTIFICATION 1 5 6 7 8 2 9 10 3 4 1. Battery 2. Headlight 3. Seat lock 4. Rear bumper 5. Handlebar 6. Rear brake lever 7. Main swutch 8. Throttle lever 9. Speed limiter 10. Front brake lever 11
Страница 12 из 39
IDENTIFICATION NUMBERS RECORD Record the vehicle identification number and engine I.D. number in the spaces provided for assistance when ordering spare parts from dealer or for reference in case the vehicle is stolen. 1. VEHICLE IDENTIFICATION NUMBER 2. ENGINE I.D. NUMBER Note: The vehicle
Страница 13 из 39
CONTROL FUNCTIONS Main switch Throttle Lever Functions of the respective switch positions are as follows: ON: Engine can be started only at this position and the headlight and taillight come on when the light switch is on. OFF: All electrical circuits are switched off. The key can be remove in this
Страница 14 из 39
Handlebar switches Start button Pressing this button, the starter starts the motor. CAUTION: See starting instructions prior to starting engine. Lights switch Turn the lights switch to the position ON to switch on the position lights and the rear-light. 1 2 3 1. Engine stop button 2. Lights switch
Страница 15 из 39
Front brake lever The front brake is located on the right handlebar. Pull it toward the handlebar to apply the front brake or parking brake. Foot brake pedal The brake pedal is located on the rigth side of the vehicle. Push down on the pedal to apply the rear brake. Parking Brake Apply the brake
Страница 16 из 39
Speed limiter The speed limiter keeps the throttle from fully opening, even when the throttle lever is pushed to the maximum. Screwing in the adjuster limits the maximum engine power available and decreases the maximum speed of the ATV. Locknut Seat To remove the seat, pull the seat lock lever
Страница 17 из 39
Fuel tank cap Remove the fuel tank cap by turning it counterclockwise. Automotive gasoline with octane number of 91 or higher may be used. After refueling, be sure to tighten the tank cap firmly. 17
Страница 18 из 39
Front shock absorber adjustment The spring preload can be adjusted to suit the vehicle’s load and riding conditions. Spring preload adjustment : To increase the spring preload, turn the adjuster in direction a. To decrease the spring preloaded, turn the adjuster in direction b. Rear shock absorber
Страница 19 из 39
PRE-OPEATION CHECKS Before using this ATV, check the following points: ITEM Brakes Parking brake Fuel tank Engine oil Throttle Wheels and tires Fittings and Fasteners Lights Batteriy ROUTINE Check operation, free plqy, fluid level and fluid leakage. Fill with DOT 4 (or DOT 3) brake fluid if
Страница 20 из 39
4. Brake operation Test the brakes at slow speed after starting to make sure they are working properly. If the brakes do not provide proper braking performance, inspect the brake pads for wear. Front and rear brakes 1. Check the operation and free play of the levers and pedal. They should move
Страница 21 из 39
Engine oil: Make sure the engine oil is at the specified level. Add oil if necessary. Recommended oil: Recommended engine oil classification: API Service SE, SF, SG type or higher. ATTENTION: Do not add any anti-friction modifier to ensure proper clutch function. Oil quantity in engine: 1L (1 gt.).
Страница 22 из 39
Throttle lever: Check to see that the throttle lever operate correctly. It must open smoothly and spring back to idle position when released. Repair if necessary for proper operation. Lights: Check the headlight and taillight to make sure they are in working condition. Repair if necessary for
Страница 23 из 39
2. The tires should be set to the recommended pressure. Recommended tire pressure: Front 25 Kpa (0,25kgf/cm², 3,6 psi) Rear 25 kPa (0,25kgf/cm², 3,6 psi) Check and adjust tire pressures when the tires are cold. Tire pressures must be equal on both sides. 3. Tire pressure below the minimumspecified
Страница 24 из 39
OPERATION WARNING: Operation ATV without being familiar with all controls is extremely dangeriìous. Freezing control cables in cold weather is extremely dangerous. Make sure everything is work smoothly before starting. To start out: 1. Release the throttle lever. ATTENTION: Always close the
Страница 25 из 39
Parking: When parking, stop the engine and shift into neutral. Turn the fuel cock to "OFF" and apply the parking brake. ENGINE BRAKE-IN ATTENTION: The first 20 Hrs for engine break-in is very important, never exceed the funning condition listed below: 1. 0-10 hours: Avoid continuous operation above
Страница 26 из 39
PERIODIC SERVICE PERIODIC SERVICE/LUBRIFICATION ITEM Valves ROUTINE Check valve clearance Adjust if necessary Spark plug Check condition Adjust gap and clean Replace if necessary Air filter Clean Replace if necessary Carburetor Check idle speed/starter operation Adjust if necessary Cylinder Check
Страница 27 из 39
ITEM Fuel line Engine oil Engine oil strainer Brake Tires Wheel bearings Steering system ROUTINE 1 month INITIAL 3 months 6 months 6 months 1 year X X X X X X X X X Check fuel hose for cracks or damage Replace if necessary Check oil level weekly Replace (Warm engine before draining.) Clean EVERY X
Страница 28 из 39
ITEM Battery ROUTINE Check specific gravity Check that the breather hose is positioned properly Check liquid height 1 month INITIAL 3 months X X WARNING: Never service the engine while still running! 28 6 months X 6 months X EVERY 1 year X
Страница 29 из 39
2. Engine oil 1. a. b. c. d. e. f. Engine oil replacement and oil strainer cleaning a. b. Engine oil level measurement Place the vehicle on a level place. Warm up the engine for several minutes and stop it. Wait a few minutes until the oil level settles before checking. Remove the dipstick and wipe
Страница 30 из 39
Idle speed adjustment NOTE: for this operation a diagnostic instrument must be used (Revolution counter). Throttle lever adjustment NOTE: Adjust the engine idling speed before adjusting the throttle lever free play. 1. Loosen the locknut. 2. Turn the adjusting bolt until the throttle lever free
Страница 31 из 39
Inspecting the brake fluid level Insufficient brake fluid may let air enter the brake system, possibly causing the brakes to become ineffective. Bofore riding, check that the brake fluid is above the lower level and replenish when necessary. Use only the designated quality brake fluid. Recommended
Страница 32 из 39
Brake level lubrification Lubrificate the pivot of each lever and pedal. Use SAE 10W30 motor oil. Drive Chain Adjustment 1. Unlock the fastening screw of swing arm. 2. Swing the rear axle bearing holder back and forth to reach suitable chain tension. 3. Lock the fastening screw of swing arm. Fuse
Страница 33 из 39
Replacing the headlight bulb If the headlight bulb is burnt, remove the headlight unit assembly, take out the defective bulb and replace a new one. Replacing the battery fluid A poorly maintained battery will corrode and discharge quickly. The battery fluid should be checked at least once a month.
Страница 34 из 39
TECHNICAL CHARACTERISTICS MODEL Dimensions: Overall length Overall width Overall height Wheel base Minimum ground clearance Minimum turning radius Basic weight: WITH OIL AND FULL FUEL TANK Engine: Engine type Cylinder arrangement Displacement Bore x stroke Compression ratio Starting system
Страница 35 из 39
MODEL QUAD DX125 Engine oil: Recommended engine oil classification : Type API Service SE,SF,SG or higher. Quantity Air filter: Fuel: Type Fuel tank capacity Carburetor: Type/quantity Manufacturer Spark plug: Type/Manufacturer Spark plug gap 1.0 L. Dry element Unleaded fuel 5,6 L Keihin/Reinmech
Страница 36 из 39
MODEL Chassis: Frame type Caster angle Transmission: Primary reduction system Secondary reduction system Secondary reduction ratio Transmission type Tire: Type Size Brake: Front brake Type Operation Rear brake Type Operation Suspension: Front suspension Rear suspension QUAD DX125 En tubes an acier
Страница 37 из 39
MODEL Shock absorber: Front Rear Wheel travel: Front Rear Electrical: Ignition system Generator system Battery/ type/voltage/capacity Bulb voltage, wattage x quantity: Headlight Taillight QUAD DX125 Coil spring/Oil damper Coil spring/Oil damper 150 mm 180 mm CDI CDI magneto 12V12V, 30w/30W x 2 12V,
Страница 38 из 39
MAINTENANCE RECORD Copies of work orders and/or receipts for parts you purchase and install will be required to document maintenance done in accordance with the warranty. The chart below is printed only as a reminder to you that the maintenance work is required. It is not acceptable proof of
Страница 39 из 39