Инструкция для HACH-LANGE SENSION+ MM340

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

Data logger

Display data

The Display data log contains Measurement data, Electrode report and
Calibration data. The stored data can be send to a printer or to a PC.
When the data log becomes full (400 data points), the oldest data point
is deleted when a new data point is added.

1. Use the   and   to select Channel 1 or Channel 2 and confirm.
2. From the main menu use the   or   to select SYSTEM. Confirm.
3. Use the   or   to select DATA LOGGER and confirm.
4. Use the   or   to select Display data and confirm.
5. Use the   or   to select

Option

Description

Measurement data Measurement data—stores automatically each time a

sample is measured

Electrode report

Electrode report—stores automatically the electrode
history and measurement conditions

Calibration data

Calibration data—stores automatically the current
calibration

Delete data

The entire measurement data or electrode report log can be deleted to
remove data that has already been sent to a printer or PC.

1. From the main menu use the   or   to select SYSTEM. Confirm.
2. Use the   or   to select DATA LOGGER and confirm.
3. Use the   or   to select Erase and confirm.
4. Use the   or   to select Measurement data or Electrode report and

confirm. Confirm again to delete the data.
The entire log is deleted at once.

Send data to a printer or to a computer

N O T I C E

The data output (printer or PC) needs to be selected first, so that the Print menu
is available (refer to

Select the data output

on page 11).

Note: Refer to

Report output

on page 13 to select the report output type.

1. From the main menu use the   or   to select SYSTEM. Confirm.
2. Use the   or   to select DATA LOGGER and confirm.
3. Use the   or   to select Print and confirm. Select one of the

following options and confirm with to print the data: Measurement
data, Electrode data, Calibration data, Calibration report or
Instrument condit.

Report output

N O T I C E

The data output (printer or PC) needs to be selected first, so that the Type of
report menu is available (refer to

Select the data output

on page 11).

Different report output types can be selected when a printer or a PC is
connected.

1. From the main menu use the or to select SYSTEM. Confirm.
2. Use the or to select Type of report and confirm.
3. When a printer or a computer and Terminal is connected, use the

or to select

Option

Description

Reduced Select Several or One sample as an output format

English 13