14

GB

Cleaning the oven door

!

 The door of LED INSIDE models cannot be removed.

Clean the glass part of the oven door using a sponge and a non-abrasive 

cleaning product, then dry thoroughly with a soft cloth. Do not use rough 

abrasive material or sharp metal scrapers as these could scratch the surface 

and cause the glass to crack.

For more thorough cleaning purposes, the oven door may be removed:

1. Open the oven door fully (see diagram).

2. Use a screwdriver to lift up and turn the small levers 

F

 located on the two 

hinges (see diagram).

F

3. Grip the door on the two outer sides and 

close it approximately half way. Pull the 

door towards you, lifting it out of its slot (see 

diagram). To replace the door, reverse this 

sequence.

To remove oven door with soft closing hinges*:

1. Open the door completely.

2. Lift the pull-out hooks located on the two 

hinges. If you cannot lift them manually, use 

a tool as a lever.

3. Completely rotate downwards the pull-out 

hooks.

4. Holding the door by its two outer sides, 

slowly close it but not completely. Pull the 

door to remove it from its seat (see figure). 

To re-assemble the door follow the procedure 

in reverse order.

5. Rotate the pull-out hooks upwards until they 

touch the front of the oven.

6. Push the pull-out hooks downwards, 

making sure they are steady and do not 

rotate forward

.

Inspecting the seals

Check the door seals around the oven regularly. If the seals are damaged, 

please contact your nearest Service Centre (see Assistance). We recommend 

that the oven is not used until the seals have been replaced.

Replacing the light bulb

To replace the oven light bulb:

1. Remove the glass cover of the 

lamp-holder.

2. Remove the light bulb and replace 

it with a similar one: halogen lamp 

voltage 230 V, wattage 25 W, cap 

G 9.

3. Replace the glass cover (see 

diagram).

!

 Do not touch the light bulb directly with your hands.

!

 Do not use the oven lamp as/for ambient lighting.

Sliding rack kit assembly

To assemble the sliding racks:

1. Remove the two frames, lifting 

them away from the spacers A (see 

figure).

2. Choose which shelf to use with the 

sliding rack. Paying attention to the 

direction in which the sliding rack is 

to be extracted, position joint B and 

then joint C on the frame.

A

B

C

Left

guide rail

Right guide

rail

Direction

of extraction