System Unit

Dimensions

 (H x W x D) 8 SFF - 1.7 x 17.1 x 23.9 inches (4.35 x 43.46 x 60.76 cm)

8 SFF - 1.7 x 17.1 x 23.9 inches (4.35 x 43.46 x 60.76 cm)

Weight

(approximate)

Maximum:

(all hard drives, power
supplies, and processors
installed)

32.04 Ib (15kg)

Minimum

(one hard drive, power
supply, and processor
installed)

22.03 lb (10kg)

Input Requirements

(for Standard 460W
PSU, see power
specifications tables for
detail on 460W, 750W
and 1200W power
supplies))

Rated Line Voltage

100 to 240 VAC

Rated Input Current

For 550W Power Supply:
6.7 A (at 100 VAC)
3.3 A (at 100 VAC)

Rated Input Frequency

47 to 63 Hz

Rated Input Power

For 550 W Power Supply:
< 670 W (at 100 VAC),
< 660 W (at 200 VAC),

BTU Rating

Maximum

For 550 W Power Supply:
2201 BTU/hr (at 100 VAC),
2153 BTU/hr (at 200 VAC)

Power Specifications

To review typical system power ratings use the Power Advisor which is
available via the online tool located at URL: 

www.hp.com/go/proliant-

energy-efficientOrwww.hp.com/go/hppoweradvisor

 - Click on the system

of interest. Example: DL160 Gen9- Follow the instructions of the next
screens.

Power Supply Output

Rated Steady-State
Power

For 550 W Power Supply:
550 W (at 100 VAC),
550 W (at 200 VAC),

Maximum Peak Power

For 550 W Power Supply:
550 W (at 100 VAC),
550 W (at 200 VAC),

System Inlet
Temperature

Standard Operating
Support

10° to 35°C (50° to 95°F) at sea level with an
altitude derating of 1.0°C per every 305 m
(1.8°F per every 1000 ft) above sea level to a
maximum of 3050 m (10,000 ft), no direct
sustained sunlight. Maximum rate of change
is 20°C/hr (36°F/hr). The upper limit and rate
of change may be limited by the type and
number of options installed. System
performance during standard operating
support may be reduced if operating with a
fan fault or above 30°C (86°F).

Extended Ambient
Operating Support

For approved hardware configurations, the
supported system inlet range is extended to
be: 5° to 10°C (41° to 50°F) and 35° to 40°C
(95° to 104°F) at sea level with an altitude
derating of 1.0°C per every 175 m (1.8°F per
every 574 ft) above 900 m (2953 ft) to a
maximum of 3050 m (10,000 ft). The
approved hardware configurations for this
system are listed at the URL:

www.hp.com/go/proliant/ashrae

QuickSpecs

HP ProLiant DL160 Generation9 (Gen9)

Technical Specifications

DA - 15031   Worldwide QuickSpecs — Version 1 — 9.9.2014

Page  34