This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid configurations
are ordered, HP recommends the use of an HP approved configurator. Contact your local sales representative for
information on configurable product offerings and requirements.
1. Factory Integrated Models must start with a CTO Server.
2. FIO indicates that this option is only available as a factory installable option.
3. All Factory Integrated Models will be populated with sufficient hard drive blanks based on the number of initial hard drives
ordered with the server.
4. Some options may not be integrated at the factory. Contact your local sales representative for additional information.
Step 1: Base Configuration (choose one of the following configurable models)
[Chassis]
HP ProLiant DL360 Gen9
4LFF Configure-to-order
Server
HP ProLiant DL360 Gen9
8SFF Configure-to-order
Server
SKU Number
755259-B21
755258-B21
Processor
2 (optional) x HP Smart Socket Guides
DIMMSlots
2 (optional) x HP Smart Socket Guides
Storage Controller
HP Dynamic Smart Array B140i
PCIe
Drive Cage
4LFF Hot Plug
8SFF Hot Plug
Network Controller
HP Embedded 1Gb Ethernet 4-port 331i Adapter
Fans
Management
iLO Management
(standard), Intelligent
Provisioning (standard),
iLO Advanced (optional),
Insight Control (optional),
HP OneView (optional)
iLO Management
(standard), Intelligent
Provisioning (standard),
iLO Advanced (optional),
Insight Control (optional),
HP OneView (optional)
USB
Ears
NOTE:
This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid
configurations are ordered, HP recommends the use of an HP approved configurator. Contact your local sales
representative for information on configurable product offerings and requirements.
NOTE:
Factory Integrated Models must start with a CTO Server.
NOTE:
FIO indicates that this option is only available as a factory installable option.
NOTE:
All Factory Integrated Models will be populated with sufficient hard drive blanks based on the number of initial hard
drives ordered with the server.
Step 2: Choose Required Options (only one of the following from each list unless
otherwise noted)
HP Processors
Select one or two processors from Core options-Processor section below,
If one processor is desired, select one xxxxxx-L21
If two processors are desired, select one xxxxxx-L21 and one xxxxxx-B21.
Up to 2 processors supported. Mixing different processor models is not supported.
DDR4 speed is the maximum memory speed of the processor. Actual memory speed may
depend on the quantity and type of DIMMs installed
For the Intel® C600 Chipset E5-2600 Series, the letter preceding the model number
indicates the
Product Line (E3, E5, E7); 2600x v#, 2 = number of CPUs in a Node, 4 is socket/segment
designation, 00 = Processor SKU, x = L for low power SKUs and v# (not yet designated) =
version number.
QuickSpecs
HP ProLiant DL360 Generation9 (Gen9)
Configuration Information - Factory Integrated Models
DA - 15033 Worldwide QuickSpecs — Version 1 — 9.9.2014
Page 17