![background image](/i/ibanez/133655/ibanez-electric-guitars-2014-prestige/h/ibanez-electric-guitars-2014-prestige-054.png)
55
➤➤
Adjustment Man
ual
EN
FX Edge III/FX Edge III-8 bridge
FX Edge III
■
1
1
2
3
4
5
6
1
Main stud
2
Saddle lock bolt
3
String holder block
4
String stopper bolt
5
Rear stud
6
Fine tuning bolt
Adjusting the action
To adjust the string height, use a slotted screwdriver to
1.
turn the main studs at the left and right of the bridge unit to
adjust the height of the entire tremolo unit. (It is not possible
to adjust the height of individual strings.)
Use an Allen wrench (3 mm) to turn the rear studs, adjusting
2.
them so that the bridge is approximately parallel with the
surface of the guitar body.
As the action will change when you adjust the rear studs, it is recommended that you check the fi nal action
after you’ve adjusted the rear studs.
To prevent the screw holes from being damaged, loosen the strings suffi ciently before you adjust the main
studs so that you will not have to use excessive force when turning the studs.
Adjusting the intonation
Use an Allen wrench (3 mm) to loosen the pressure
1.
pad bolts of the locking nut, and loosen the strings
suffi ciently.
Use an Allen wrench (2 mm) to loosen the saddle
2.
lock bolt, and adjust the saddle position.
Before checking the intonation, fi rmly tighten the saddle lock
bolts and tune the guitar correctly. When you’ve fi nished
making adjustments, tighten the saddle lock bolts and the
pressure pad bolts of the locking nut.
Prestage Manual.indb 55
Prestage Manual.indb 55
8/9/2013 11:28:36 AM
8/9/2013 11:28:36 AM