EN
10
Wash cycles
The number and type of wash cycles and options may vary depending on the dishwasher model.
Wash-cycle data is measured under laboratory conditions according to European Standard EN 50242.
Based on the different conditions of use, the wash-cycle duration and data can change.
Wash Cycle
Drying
Options
Wash Cycle
Duration
Water
Consumption
(l/cycle)
Energy
Consumption
(kWh/cycle)
1.
Eco
Yes
Delayed start – Tabs –
Half Load
03:10’
9,0
0,93
2. Intensive
Yes
Delayed start – Tabs –
Half Load
02:00’ - 03:10’
14,0 - 15,5
1,50 - 1,80
3. Normal
Yes
Delayed start – Tabs –
Half Load
01:30’ - 02:30’
14,5 - 16,0
1,20 - 1,35
4. Delicates
Yes
Delayed start – Tabs –
Half Load
01:40’
11,0
1,10
5.
Rapid
No
Delayed start – Tabs
00:30’
9,0
0,50
6. Prewash
No
Delayed start – Half Load
00:12’
4,5
0,01
7.
Hygiene
Yes
Delayed start
01:20’
10,0
1,25
8. Extra
No
Delayed start - Extra Light (Half Load)
01:00’
11,0
n.a.
Instructions on wash-cycle selection and detergent dosage
1.
The ECO wash cycle is the standard cycle to which the energy label data refers. It can be used to wash crockery with a normal
soil level and is the most efficient cycle in terms of energy and water consumption for this type of crockery.
29 gr/ml + 6 gr/ml** – 1 Tab
(**Quantity of pre-washing detergent)
2.
Heavily soiled dishes and pans (not to be used for delicate items). 35 gr/ml – 1 Tab
3.
Normally soiled pans and dishes. 29 gr/ml + 6 gr/ml** – 1 Tab
4.
Cycle for delicate items, which are more sensitive to high temperatures 35 gr/ml – 1 Tab
5.
Fast cycle to be used for slightly dirty dishes (ideal for 2 place settings) 25 gr/ml – 1 Tab
6.
Pre-wash while awaiting completion of the load with the dishes from the next meal. No detergent.
7.
High-temperature disinfecting cycle. Ideal to clean crockery and feeding bottles. 30 gr/ml – 1 Tab
8
Large crockery.
(Do not use on delicate items)
35 gr/ml – 1 Tab
Standby consumption: Left-on mode consumption: 5,0 W - Off mode consumption: 0.5 W
n.a. non applicable
Notes:
Optimum performance levels when using the “Rapid” cycle can be achieved by respecting the specified number of place settings.
To reduce consumption even further, only run the dishwasher when it is full.
Note for Test Laboratories:
for information on comparative EN testing conditions, please send an email to the following address:
assistenza_en_lvs@indesitcompany.com
