![background image](/i/infiniti/152149/infiniti-g35-sedan-2008/h/infiniti-g35-sedan-2008-395.png)
Use the following steps to mount the license
plate:
Before mounting the license plate, confirm that
the following parts are enclosed in the plastic
bag.
Only use the recommended mounting position
or Intelligent Cruise Control (ICC) sensor ob-
struction (if so equipped) may result.
●
License plate bracket
●
J-nut × 2
●
Screw × 2
●
Screw grommet × 2
SEDAN
1. Park the vehicle on flat, level ground.
2. Locate the center position indicator
s
A
on
the lower part of the grille. Line up the
marks under the top of the front bumper
s
B
with the tabs
s
C
on the license plate
bracket. Hold the license plate bracket in
place.
3. Mark the center of the hole
s
C
with a
felt-tip pen.
4. Carefully drill two pilot holes using a 0.39
in (10 mm) drill bit at the marked loca-
tions.
(Be sure that the drill only goes
through the bumper fascia.)
Sedan
STI0496
INSTALLING FRONT LICENSE PLATE
Technical and consumer information
9-15
w
—
—
07/14/07—pattie
X