Rear-facing
Follow these steps to install a rear-facing child
restraint using the vehicle seat belt in the rear
seat:
1.
Child restraints for infants must be used in
the rear-facing direction and therefore
must not be used in the front seat.
Position
the child restraint on the seat. Always
follow the restraint manufacturer’s in-
structions.
2. Route the seat belt tongue through the
child restraint and insert it into the buckle
until you hear and feel the latch engage.
Be sure to follow the child restraint manu-
facturer’s instructions for belt routing.
3. Pull the shoulder belt until the belt is fully
extended. At this time, the seat belt re-
tractor is in the Automatic Locking Retrac-
tor (ALR) mode (child restraint mode). It
reverts to Emergency Locking Retractor
(ELR) mode when the seat belt is fully
retracted.
SSS0100
Rear facing — step 2
SSS0654
Rear facing — step 3
SSS0655
1-32
Safety — Seats, seat belts and supplemental restraint system
w
—
—
07/14/07—pattie
X