Инструкция для INFINITI G37 Convertible (2009)

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

NOTE:

Once you have pushed and released the training
button on the garage door opener’s motor and
the “training light” is lit, you have 30 seconds in
which to perform step 7. For convenience, use
the help of a second person to assist when per-
forming this step.

7. Quickly (within 30 seconds of pushing

and releasing the garage door opener
training button) and firmly push and re-
lease the HomeLink

姞

button you’ve just

programmed.

Push

and

release

the

HomeLink

姞

button up to three times to

complete the training.

8. Your HomeLink

姞

button should now be

programmed. To program the remaining
HomeLink

姞

buttons for additional door or

gate openers, follow steps 2 through 8
only.

NOTE:

Do not repeat step 1 unless you want to “clear”
all previously programmed HomeLink

姞

buttons.

If you have any questions or are having diffi-
culty programming your HomeLink

姞

buttons,

please refer to the HomeLink

姞

web site at:

www.homelink.com or call 1-800-355-3515.

PROGRAMMING HOMELINK

姞

FOR

CANADIAN CUSTOMERS

Prior to 1992, D.O.C. regulations required hand-
held transmitters to stop transmitting after 2
seconds. To program your hand-held transmit-
ter to HomeLink

姞

, continue to push and hold

the HomeLink

姞

button (note steps 2 through 4

under “Programming HomeLink

姞

”) while you

push and re-push (“cycle”) your hand-held
transmitter every 2 seconds until the indicator
light flashes rapidly (indicating successful pro-
gramming).

NOTE:

If programming a garage door opener, etc., it is
advised to unplug the device during the “cy-
cling” process to prevent possible damage to
the garage door opener components.

OPERATING THE HOMELINK

姞

UNIVERSAL TRANSCEIVER

HomeLink

姞

Universal Transceiver (once pro-

grammed) may now be used to activate the
garage door, etc. To operate, simply push the
appropriate programmed HomeLink

姞

Universal

Transceiver button. The red indicator light will
illuminate while the signal is being transmitted.

PROGRAMMING TROUBLE-DIAGNOSIS

If HomeLink

姞

does not quickly learn the hand-

held transmitter information:

●

replace the hand-held transmitter batteries
with new batteries.

●

position the hand-held transmitter with its
battery

area

facing

away

from

the

HomeLink

姞

surface.

●

push and hold both the HomeLink

姞

and

hand-held transmitter buttons without inter-
ruption.

●

position the hand-held transmitter 2 to 5 in
(50 to 127 mm) away from the HomeLink

姞

surface. Hold the transmitter in that position
for up to 15 seconds. If HomeLink

姞

is not

programmed within that time, try holding
the transmitter in another position - keeping
the indicator light in view at all times.

If you continue to have programming difficul-
ties, please contact the INFINITI Consumer Af-
fairs Department. The phone numbers are lo-
cated in the Foreword of this Owner’s Manual.

2-52

Instruments and controls

췽

—

—
04/03/09—tbrooks

墍