![background image](/i/infiniti/151165/infiniti-g37-convertible-2009/h/infiniti-g37-convertible-2009-408.png)
1. Park the vehicle on flat, level ground.
2. Locate the center position indicator
䊊
A
on
the lower part of the grille. Measure
straight down from the edge where the
bumper and grille meet to the aligning
holes
䊊
B
, keeping the tape measure lined
up with the center position indicator.
3. Mark the holes
䊊
B
with a felt-tip pen.
4. Carefully drill the two aligning holes
䊊
B
using a 0.39 in (10 mm) drill bit at the
marked locations.
(Be sure that the drill
only goes through the bumper fascia.)
5. Line up the bosses
䊊
C
or license plate
bracket with the holes and hold the li-
cense plate bracket in place.
6. Mark the center of the holes
䊊
D
with a
felt-tip pen.
7. Carefully drill the two pilot holes using a
0.39 in (10 mm) drill bit at the marked
locations.
(Be sure that the drill only goes
through the bumper fascia.)
8. Insert grommets into the hole on the
fascia.
9. Insert a flat-blade screwdriver into the
grommet hole to add 90° turn onto the
part
䊊
E
.
STI0551
Technical and consumer information
9-13
췽
—
—
04/06/09—tbrooks
墍