![background image](/i/karcher/165568/karcher-ic-15-240-w-adv/h/karcher-ic-15-240-w-adv-022.png)
-
9
1 Tightening pinion
Loosen the tightening screw on the rear
side of the tightening pinion.
Press down the tightening pinion and
fasten it with screws.
Check the chain tension again.
Note:
With model 1.183-904.0, the fine
dust filter is part of the scope of the deliv-
ery.
Tilt the suction head upward.
1 Screw
2 Flat fold filter
3 Spring pin
4 Handle for filter cleaning
Pull out the spring plug.
Pull out the filter cleaner.
Turn out the 4 screws and remove the
holder.
Remove both the flatfold filters and re-
place them with new flat fold filters.
Replace holder and tighten the screws.
Replace the filter cleaner handle.
Plug in the spring plug.
Replacing the fine dust filter (option)
Troubleshooting
Fault
Remedy
Appliance cannot be started
Refuel
Open fuel cock
Check fuel system, connections and joints
Check fuse of electrical starter; replace if required.
Charging battery
Check and clean spark plug, replace if necessary.
Inform Kärcher Customer Service.
Engine is running erratically
Clean or replace air filter
Check fuel system, connections and joints
Inform Kärcher Customer Service.
Engine is running but machine is
not moving
Check setting of freewheel lever
Inform Kärcher Customer Service.
Engine is running but machine is
only moving slowly
Allow machine to warm up for approx. 3 minutes in sub-zero temperatures
Inform Kärcher Customer Service.
Insufficient vacuum performance
Check washers at the suction head
Open the exhaust openings of suction operations (only for Leaf Blower attachment set)
Clean the hole-plate or fine dust filter (in Fine dust filter attachment set) in the suction head
22
EN