7

ENG

ENGLISH

ASSEMBLING AND PREPARING

Using the Kensington security system 

The Kensington security system connector is 
located at the back of the Monitor set. For more 
information of installation and using, refer to the 
manual supplied with the Kensington security 
system or visit 

http://www.kensington.com.

Connect the Kensington security system cable 
between the Monitor set and a table.

The Kensington security system is optional. 

You can obtain it from most electronics stores.

note

When you adjust the angle, do not hold the 

bottom of the Monitor set frame as shown on 

the following illustration, as may injure your 

fingers.

Do not touch or press the screen when 

adjusting the angle of the monitor.

Do not hold this set like below picture.Monitor 

screen can detach from stand base and injure 

your body.

wARnInG

Tilt from +20 to -5 degrees up or down to adjust 

the angle of the Monitor set to suit your view.

note

Front

Rear