![background image](/i/lincoln/156775/lincoln-navigator-l-2014-qrg/h/lincoln-navigator-l-2014-qrg-003.png)
2 01 4 N A V I G A T O R
4
5
1
Lighting Control
Switches the headlamps on.
Switches the headlamps off.
Switches on the parking lamps.
Autolamps: Automatically turns the
exterior lamps on or off based on
available daylight.
Switches on fog lamps when you pull the
control toward you. You can switch the
fog lamps on when the ignition is on, the
lighting control knob is in any position
other than the off position and you do not
switch the high beams on.
2
Parking Brake
3
Windshield Wipers and Washers
Rotate the end of the control lever away
from you or toward you to increase or
decrease the speed of the wipers.
To use the washer feature, push the end
of the lever:
Quickly for a single swipe without fluid.
Hold briefly for three swipes with
washer fluid.
Hold for a longer wash cycle.
To operate your rear window wiper:
Rotate the rear wiper control to
1
(slower
intermittent speed),
2
(faster intermittent
speed) or
0
(off). For a rear wash cycle,
rotate and hold the
control to either
the top or bottom position to activate the
rear washer. The control will return to the
2
or
0
position when you release it.
Note:
For optimal wiper performance, clean
your blades and glass regularly. Refer to
your
Owner’s Manual
for more information.
4
Cruise Control
To set the speed:
A. Press and release
ON.
B. Accelerate to the desired speed.
C. Press
SET+
and take your foot
off the accelerator.
To set a higher or lower speed, press
and hold
SET+
or
SET–
until you reach
the desired speed. Additionally, you
can press and release either button to
change your set speed in approximately
1 mph (2 km/h) increments.
To cancel a set speed, tap the brake
pedal. The set speed will not be erased.
To return to a previously set speed,
press
RESUME
.
To switch off, press
OFF
or switch off
the ignition.
5
Information Display
S
hows important vehicle information
through a constant monitor of vehicle
systems. The display will notify you of
potential vehicle problems by showing
system warnings followed by a long
indicator tone. For more details about
your information display functions,
please see your
Owner’s Manual
.
6
Service Engine Soon Light
Lights briefly when you switch
the ignition on. If it remains on or blinks
after you start the engine, the On-Board
Diagnostics (OBD-II) system has detected
a malfunction. Drive in a moderate fashion
(avoid heavy acceleration and deceleration)
and contact an authorized dealer as soon
as possible.
7
Hazard Control
4
Instrument Panel