Chapter 3: Hardware Overview
9
Chapter 3: Hardware Overview
This chapter describes the connectors and hardware features
of the following GSR speakers:
GSR10 and GSR12
The GSR10 and GSR12 both use the same type of amplifier
and provide the same front and back panel features. These
common features are described in the following sections. (For
the GSR18, see “GSR18” on page 11.)
Front
HF Driver and Horn
GSR10
25mm titanium compression driver.
GSR12
34mm titanium compression driver.
Front Grille
Do not block or remove the front grille.
LF Driver
GSR10
10-inch neodymium motor driver.
GSR12
12-inch neodymium motor driver.
Top, Sides, and Bottom
Handles (Top and Side)
Handles are provided on the top and sides for carrying the
speakers.
Feet
Feet are provided on the bottom of the cabinets for standing
on the floor or stacking. These rubber feet acoustically decou-
ple the speaker from the surface it is sitting on, and prevent
the speaker from moving due to vibration.
M10 Flypoints
The GSR10 and GSR12 both provide M10 inserts for flypoints
and rigging on the top, bottom, and back of the cabinet.
Pole Mount
This socket, found on the bottom of the GSR speakers, is a
standard 1 3/8-inch (36mm) pole mount that lets you mount
the speaker on a stand (or on a pole inserted into the pole
mount receptacle found on the top of the GSR18).
Front of the GSR10 (left) and GSR12 (right)
