[Страница 10/12] - Руководство по эксплуатации: студийный монитор M-AUDIO SP-8B

Инструкция для M-AUDIO SP-8B

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

Appendix A - Technical Specs

Type: Two-way studio reference

LF Driver: 8-inch magnetically-shield mineral-filled polypropylene curved
cone with high temperature voice coil and damped rubber surround

HF Driver: 1-inch magnetically-shield natural silk dome

Frequency Response: 33Hz - 22kHz

Crossover Frequency: 1.8kHz

LF Amplifier Power: 55W

HF Amplifier Power: 45W

S/N Ratio: > 100dB below full output, 20kHz bandwidth

Input Connectors: One XLR balanced input connector; one TRS balanced/
unbalanced input connector

Polarity: Positive signal at + input produces outward low-frequency cone
displacement

Input Impedance: 20k ohms balanced, 10k ohms unbalanced

Input Sensitivity: 200 mV input produces full output with volume control at
maximum

Protection: RF interference, output current limiting, over temperature, turn
on/off transient, subsonic filter, external main fuse

Indicator: Power on/off indicator on rear panel

Power Requirements: Dual-voltage (selectable by rear-panel switch) for either
115V/~60Hz, 230V/~50Hz; powered via detachable 3-circuit line cord

Cabinet: vinyl-laminated MDF

Dimension: 380 mm (H) x 250 mm (W) x 300 mm (D)

Weight: 20.32 lb/unit (without packing)

Remarks: Above specifications are subject to change without notice

Оглавление инструкции

Страница 1 из 13
Studiophile SP-8B Users Manual Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 What’s in the Box? . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 Studiophile SP-8B
Страница 2 из 13
Introduction Thank you for choosing the SP-8B Studiophile Series bi-amplified powered studio reference monitor speakers. M-Audio is well known for digital audio interface technology, digital converters, audio pre amps and mixers. Now, after long research and development, the Studiophile SP-8B is
Страница 3 из 13
2. Tweeter By employing a specially developed 1" silk dome with magnetic shielding, the tweeter can deliver distortion-free original sound and offer extremely natural response. It minimizes reaction time by using fabric silk for excellent delivery, and also minimizes resonance by adapting a unique
Страница 4 из 13
Rear Panel: 1. XLR INPUT: This jack accepts XLR input connections with either balanced or unbalanced wiring. The signal of the XLR INPUT is summed together with the TRS INPUT through a balanced input amplifier, allowing both inputs to be used simultaneously. Input specifications apply to both
Страница 5 из 13
3. PRODUCT LABEL: This label contains the model and serial number information. 4. VENT PORT: This port aids in reproduction of very low frequencies by discharging frequencies below 30 Hz.. 5. VOLUME CONTROL: Use the volume control to set the output sound pressure from the SP-8B to proper levels as
Страница 6 из 13
Installation For optimal performance of the SP-8B, please read the following thoroughly and carefully prior to installation. Precautions Handling: Please do not grab the speaker cones. The SP-8B set is packaged in the box tightly, so your attention is required when taking the monitors out of the
Страница 7 из 13
1 2 e lum Vo 2 3 1 Inp R XL S TR Inp e lum ut TR R XL S 1 1 2 3 we Po r N IOOCK T SH U RICEN A ELECTT OP NO CK OF DO RIS ! l.• ba Un ms oh W• 0k l./1 0mV• r: 30 Ba we ms ity: 20p. Po k oh itiv Am p: 20t Sens / HF Im ut •Inpu 40W r: • Inp we p. Po •LF Vo S TR 3 ut R XL 2 2 3 1 1 2 S TR 3 R XL 3 we
Страница 8 из 13
Placing the SP-8Bs Placing the speakers is one of the most important procedures in order to monitor sound accurately. To monitor with the SP-8Bs at their maximum capability, an appropriate listening environment and correct placement is required. Please, refer to the following in order to place the
Страница 9 из 13
3. Place the SP-8Bs vertically with the woofer on the bottom. Placing the SP-8Bs horizontally is not recommended. Remarks: DO NOT place any obstacles that may block the flow of air in front or between the SP-8Bs. Also remove reflective materials such as glass, mirrors or metal from the monitoring
Страница 10 из 13
Appendix A - Technical Specs Type: Two-way studio reference LF Driver: 8-inch magnetically-shield mineral-filled polypropylene curved cone with high temperature voice coil and damped rubber surround HF Driver: 1-inch magnetically-shield natural silk dome Frequency Response: 33Hz - 22kHz Crossover
Страница 11 из 13
Appendix B - Block Diagram 11
Страница 12 из 13
One Year Warranty MIDIMAN warrants that this product is free of defects in materials and workmanship under normal use for a period of one year from purchase date, so long as the product is: owned by the original purchaser; the original purchaser has proof of purchase from an authorized MIDIMAN
Страница 13 из 13

Инструкция для M-AUDIO SP-8B

Инструкции и руководства похожие на M-AUDIO SP-8B

Другие инструкции и руководства из категории студийный монитор