M-Audio Studiophile DSM1 Guide

10

Connecting Power

To connect power to the speakers:

1  

Make sure you have set the Voltage Selector 

and installed the proper fuse before proceeding. 
(See “Setting the Voltage” on page 9 for details.) 

2  

Connect the included AC power cord to the 

AC connector on the back panel of each speaker 
(one power cord is included with each speaker). 

3  

Connect the other end of the AC power cord 

to your power source. 

Power Up and Power Down

Always power up your speaker system last (al-
lowing mixers, recorders and other devices to 
fully power up first). 

Conversely, always mute (or power off) your 
speaker system first, before powering off other 
devices in your studio. 

Connecting Audio

This section explains how to make analog and 
digital audio connections to DSM1 speakers. 

Connecting Analog Inputs

To connect an analog source: 

1  

Do any of the following:

• Connect a balanced XLR cable to the 

XLR In connector on the back panel of the 
speaker. 

• Connect a balanced 1/4-inch balanced TRS 

cable to the TRS In connector on the back 
panel of the speaker. 

2  

Connect the other end of the cable to the an-

alog audio source (for example, an analog out-
put from your monitoring system). 

AC connector

AC
connector

Analog input section

If you need to connect an unbalanced ana-
log source, see “Analog Inputs” on page 4. 

Analog Input (XLR)

Analog Input (TRS)

Input Sensitivity
switch