ENGLISH
10
about danger that can be caused by its
improper usage.
•
Do not leave children unattended not to
let them use the unit as a toy.
•
For children safety reasons do not leave
polyethylene bags, used as a packaging,
unattended.
Attention!
Do not allow children to play with
polyethylene bags or packaging film.
Danger
of suffocation!
•
Never pull the power cord when discon-
necting the unit from the mains, take the
power adapter and carefully remove it
from the mains socket.
•
Never use the unit if the power adapter or
the adapter cord is damaged, if the unit
works improperly or after it was dropped.
•
Do not disassemble the unit by yourself,
if any malfunction is detected or after the
unit was dropped, apply to the nearest
authorized service center.
•
Transport the unit in the original pack-
age only.
•
Keep the unit out of reach of children and
disabled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD
USAGE ONLY
USING THE HAIR CLIPPER
After unit transportation or storage under
winter (cold) conditions, it is necessary
to keep it for at least two hours at room
temperature before switching on.
Battery charging
Full charging of the battery is enough for
approximately 25-30 minutes of continuous
operation (depending on the hair structure).
If the blades (2) motion suddenly slows down
or the indicator (4) goes out, charge the unit.
–
Unwind the power adapter cord (6) to its
full length and connect the power cord
jack to the connector (5).
–
Insert the power adapter into the mains
socket, the charging indicator (4) will light
up.
–
After charging, unplug the power adapt-
er, the indicator (4) will go out. Then dis-
connect the cord from the hair clipper.
Notes:
•
Before using the unit for the first time
charge the battery completely, that takes
no less than 10 hours.
•
Full cycle of recharging is no less than
8 hours.
•
Always unplug the unit after battery
charging.
•
Do not switch the unit on with the switch
(1) during the battery charging.
•
Charge the unit after its complete dis-
charge (the unit does not switch on).
Before taking the unit away for storage,
charge the battery completely.
•
If you did not use the unit for 2 months
or more, charge the battery completely
before use.
Lubricating oil
–
To maintain the hair clipper in a good con-
dition, you should lubricate the blades (2)
after every haircutting. Do not use vegeta-
ble oil or oil that includes solvents. Solvents
will evaporate, leaving thick grease that
may slow down the blades motion.
–
For lubricating the blades (2) use only the
oil (9) supplied with the unit.
HAIR CUTTING GUIDES
–
Hair should be clean and dry while cutting.
–
Before cutting hair, switch the hair clipper
on by moving the power switch (1) to the
position “ON” and make sure that the hair
clipper operates normally and the blades
move smoothly. If there is excess oil on
the blades, remove it with a dry cloth.
–
Seat the person so that his/her head is
approximately at your eye level, cover his/
her shoulders with a towel and set hair
with the comb (7).
Reminder
•
Always cut off a little amount of hair at a
time – you can always return to the cut
area again for additional cutting later.
MW-2109_105 x148.indd 10
15.01.2014 15:37:33
