![background image](/i/mitsubishi/156132/mitsubishi-spacegear-1997/h/mitsubishi-spacegear-1997-030.png)
30
Figure 34
: Replace an interior light
by lifting off the cover at the
long
edge
.
or more times around the pulley - it will self lock and grip the pulley, see Figure 33 for
application to the tightening stage.
(9)
Remove the pulley - it slides off in the forward direction. Check that shaft and
keys are still fine.
(10)
Fit new pulley - align with key and slide on. Tighten hex head firmly in the
clockwise direction <unknown torque, I used 150 Nm as a guess>. To do this
you will have to restrain the pulley with either (a), (b) or (d) above.
(11)
Reassemble other components in the reverse order.
7.7
Changing cabin lights
To replace an interior light on the roof, use a
screwdriver to gently prise off the cover. You
must prise on the long edge of the fitting, see
Figure 34, not on the short edge. The
replacement bulb has pointed ends and is 10W
power. The designation is Festoon globe 12V
10W 10x31mm (e.g. Narva part 47269-1). It can
go in either way. Then clip the cover back on - it
only accepts one orientation.