7
MS-7641
installing Memory Modules
the memory module has only one notch on the center and will only fit in the
right orientation.
insert the memory module vertically into the diMM slot. then push it in until
the golden finger on the memory module is deeply inserted in the diMM slot.
the plastic clip at each side of the diMM slot will automatically close when the
memory module is properly seated. you can barely see the golden finger if the
memory module is properly inserted in the diMM slot.
Manually check if the memory module has been locked in place by the diMM
slot clips at the sides.
.
2.
3.
Notch
Volt
iMPortANt
in dual-Channel mode, make sure that you install memory modules of the same
type and density in different channel diMM slots.
to enable successful system boot-up, always insert the memory modules into
the diMM first.
*
*
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
