![background image](/i/olympus/171203/olympus-dp26/h/olympus-dp26-011.png)
8
DP26
11. If the exposure time is set less than 1/15 seconds, the LIVE image cannot be displayed by the frame rate
more than 15fps.
12. The traceability of auto white balance control deteriorates when the specimen contains little white area.
13. If the microscope light source is set too bright, color unevenness may occur in photographed images.
Should this be the case, adjust the brightness to an appropriate level (for example, by lowering the lamp
voltage or by inserting a neutral filter).
14. To prevent destruction of the recorded image (data), never perform the following action during recording
of a still image or movie;
•
turning power OFF;
•
disconnecting the AC adapter;
•
disconnecting the camera cable;
15. When combining to CX or CKX, set the light volume of the microscope illumination closer to the
maximum level in order to gain the best color reproduction.
1. The camera head uses precision components. Handle it with care and avoid subjecting it to a sudden
or severe impact. Also note that the microscope does not have a waterproof construction.
2. The image displayed on the monitor may be affected when it is used near equipment generating strong
electromagnetic waves. To avoid interference during operation, keep the system far from any source of
electromagnetic waves.
3. Do not use the camera in areas where it may be subjected to direct sunlight, high temperature and
humidity, dust or vibrations. (For the operating environment conditions, see “SPECIFICATIONS” on page
19.)
4
Getting Ready