Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.
Дополнительно: Чтение инструкции онлайн
Страница: (35 из 36)
навигация
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
Оглавление инструкции
Страница 1 из 37 INSTRUCTIONS DP26 MICROSCOPE DIGITAL CAMERA This instruction manual is for the Olympus Microscope Digital Camera Model DP26. We recommend that you study this manual thoroughly before operating the camera and familiarize yourself fully with the use of this camera, which is important to ensure the
Страница 2 из 37 This device complies with the requirements of both directive 2004/108/EC concerning electromagnetic compatibility and directive 2006/95/EC concerning low voltage. In accordance with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment, this symbol indicates that the product
Страница 3 из 37 DP26 CONTENTS IMPORTANT – Be sure to read this section for safe use of the equipment. – 1-10 1 Intended Use....................................................................4 2 PC and Software............................................................4 3 Conformity of the
Страница 4 из 37 IMPORTANT The DP26 microscope digital camera is designed to be connected to a camera adapter mounted on an Olympus UIS2/UIS series microscope for recording of microscopic magnified images. When the DP26 is used with a camera adapter from other manufacturers than Olympus, the optical performance may
Страница 5 из 37 DP26 6. To prevent the microscope from toppling down, avoid using microscope attachments that may make the total height of the microscope above 1 meter when they are attached. 7. The AC adapter and camera generate heat after they have been used for a long period of time. To avoid moderate
Страница 6 из 37 Caution If the equipment is used in a manner not specified in this manual, the safety of the user may be imperiled. In addition, the equipment may also be damaged. Always use the equipment as outlined in this instruction manual. The following symbols are used to set off text in this instruction
Страница 7 из 37 DP26 1 Intended Use This device is intended to be used for the capture of digital images for non-clinical diagnostic purposes. 2 PC and Software When using desktop PC or laptop PC 1. Olympus will not assume any liabilities for any damage due to the use or non-usability of this system, including
Страница 8 из 37 Recommended operating environment Common to Desktop PC/Laptop PC (except No. 7) No. Item Operating Environment 1 PC Intel Pentium 4, Intel Xeon or Intel Core Duo (or equivalent) 2 Memory Windows® 7, Windows Vista® : 2 GB or more (3 GB or more recommended) Windows®XP:1024MB RAM 3 HD space 1 GB
Страница 9 из 37 DP26 Trademark information Windows® is a registered trademark of Microsoft Corporation, USA. All of other brand names and product names mentioned in this manual are trademarks or registered trademarks of their respective owners. Before installation Windows® 7, Windows Vista® Installation is
Страница 10 из 37 4. Combinations of this product and non-Olympus microscopes have not been evaluated extensively. Non-Olympus microscopes and commercially available C-mount lenses can be used provided that they match a CCD with a size of no less than 2/3 inch and the lens projection length from the C-mount body
Страница 11 из 37 DP26 11. If the exposure time is set less than 1/15 seconds, the LIVE image cannot be displayed by the frame rate more than 15fps. 12. The traceability of auto white balance control deteriorates when the specimen contains little white area. 13. If the microscope light source is set too bright,
Страница 12 из 37 5 Maintenance and Storage 1. To clean the lenses and other glass components, simply blow dirt away using a commercially available blower and wipe gently using a piece of cleaning paper (or clean gauze). If a lens is stained with fingerprints or oil smudges, wipe it with gauze slightly moistened
Страница 13 из 37 1 SYSTEM CHART DP26 DP26-CU Camera head D26-CU IEEE1394b cable (9pin 9pin) DP2-DKTB 1394PCIe board Desktop PC* Camera adapter DP21-DKT DP21-LPT cellSens Standard Software IEEE1394a cable (9pin 6pin) DP2-TWAIN TWAIN Driver (provided only by downloading from website) IEEE1394a cable (9pin 4pin) AC
Страница 14 из 37 2 NOMENCLATURE Camera head Main switch 6 Pilot LED Camera cable connector Camera cable Attached with DP2-DKTB (9pin - 9pin) Attached with DP21-DKT (9pin - 6pin) Attached with DP21-LPT (9pin - 4pin) 11 C-mount thread
Страница 15 из 37 3 INSTALLATION DP26 1 2 1 Fig. 1 0.63x (FN 17.5) Field number 22 1x (FN 11) Fig. 2 Installing the Camera Head Screw in the U-TV1XC C-mount camera adapter 1 into the mount thread at the bottom of the camera head 2. If you use a different C-mount camera adapter, follow its instruction manual. As the
Страница 16 из 37 2 2 1 Fig. 3 Connecting the Camera Cable • The cords and cables are vulnerable to bend or twist. Do not apply excessive force to them. • Be sure to switch off the camera head and PC before connecting. }When connecting the cable, insert the connector plug in the proper direction. (Example: Camera
Страница 17 из 37 DP26 3 2 1 Fig. 4 4 3 Fig. 5 Connecting the AC adapter (necessary only when a laptop PC is connected) • Always use the AC adapter provided by Olympus. Using an other AC adapter will result in malfunction or damage. • The cords and cables are vulnerable to bend or twist. Do not apply excessive force
Страница 18 из 37 Power supply to the camera The camera head of the DP26 has a main switch. Set this switch to ON when using the camera. The pilot LED on the camera head lights when power is supplied to the camera head. When a desktop PC or controller is connected The camera is powered from the desktop PC or
Страница 19 из 37 4 IMAGE RECORDING PROCEDURE DP26 4-1 Software • When DP2-TWAIN or cellSens is installed, the 1394 driver is also replaced with the dedicated driver for the DP26. When this driver is installed, other 1394 devices except Olympus Digital Camera for Microscope cannot be operated though connected. (Note
Страница 20 из 37 4-2 Image Recording Procedure For detail use procedures, refer to the Instruction Manual or Help of Software you will use. Brightfield Observation Flow Set up the microscope. Perform framing and focusing. Set the exposure mode. Exposure mode? Exposure mode? Auto Select the area (30% or 1%) Manual
Страница 21 из 37 6 SPECIFICATIONS System Image pickup device Item Size Effective pixels Scanning method Color filters Recording area Max. recording pixels Camera mount ISO speeds Metering method Exposure control Exposure time Image display speed (Frame rate) DP26 Specifications C-mount CCD camera unit 2/3-inch
Страница 22 из 37 Item Input/output connectors Image sizes, File formats Applicable OS Power consumption (Camera head) Storage environment Operating environment Specifications DC input: Main power supply Camera: IEEE 1394b Dependent on compatible application Windows® 7 Ultimate / Professional (32bit / 64bit) Windows
Страница 23 из 37 7 TROUBLESHOOTING GUIDE DP26 Under certain conditions, the performance of the camera may be adversely affected by factors other than defects. If problems occur, please review the following list and take remedial action as needed. If you cannot solve the problem after checking the entire list,
Страница 24 из 37 Problem c) Live image is not displayed. Cause Remedy The camera cable is connected Connect the camera cable correctly. improperly. The microscope illumination is off. Turn on the microscope illumination, The microscope is not set to the adjust the lighting and focusing camera light path. The
Страница 25 из 37 DP26 Problem e) Picture is too bright. f) Picture is too dark. Cause Remedy Exposure correction is set in the + Set the desired exposure correction direction. value. The metering area is set to a dark Move the metering area to the area area outside the region of interest. where you want to obtain
Страница 26 из 37 Problem Cause Remedy g) The colors in the picture are The area selected in white balance Select a white area as the rectangular strange. adjustment was improper. white balance adjustment area. The RGB balance is adjusted Perform manual white balance improperly in manual white balance adjustment to
Страница 27 из 37 DP26 Problem Cause Remedy i) The DP2-TWAIN or cellSens The resolution setting of the screen Set the resolution setting at 1280 x window is not displayed correctly is incorrect. 1024 or more in the properties of or the menu characters are not the screen. The large font has been selected Select a
Страница 28 из 37 n PROPER SELECTION OF THE POWER CORD If no power cord is provided, please select the proper power cord for the equipment by referring to “ Specifications ” and “ Certified Cord ” below: In case you use a non-approved power cord for Olympus products, Olympus can not warrant the electrical safety of
Страница 29 из 37 DP26 Country Agency Certification Mark Country Agency Argentina IRAM Italy IMQ Australia SAA Japan JET, JQA, TÜV, UL Japan/METI Austria ÖVE Netherlands KEMA Belgium CEBEC Norway NEMKO Canada CSA Spain AEE Denmark DEMKO Sweden SEMKO Finland FEI Switzerland SEV France UTE United Kingdom ASTA BSI
Страница 30 из 37 Table 2 HAR Flexible Cord APPROVAL ORGANIZATIONS AND CORDAGE HARMONIZATION MARKING METHODS Approval Organization 27 Printed or Embossed Harmonization Marking (May be located on jacket or insulation of internal wiring) Alternative Marking Utilizing Black-Red-Yellow Thread (Length of color section in
Страница 31 из 37 DP26 Österreichischer Verband für Elektrotechnik (ÖVE) <ÖVE> <HAR> 30 10 50 Danmarks Elektriske Materialkontroll (DEMKO) <DEMKO> <HAR> 30 10 30 National Standards Authority of Ireland (NSAI) <NSAI> <HAR> 30 30 50 Norges Elektriske Materiellkontroll (NEMKO) NEMKO <HAR> 10 10 70 Asociacion