4.Junior User Guidebook
Connect the probe tip and the ground clamp to the connector of the probe
compensator.
3.
Press the "Autoset" Button.
The square wave of 1 KHz frequency and 5V peak-peak value will be displayed in
several seconds (see
Figure 4-6
Auto set
Check CH2 by repeating Step 2 and Step 3.
How to Implement the Probe Compensation
When connect the probe with any input channel for the first time, make this
adjustment to match the probe with the input channel. The probe which is not
compensated or presents a compensation deviation will result in the measuring error
or mistake. For adjusting the probe compensation, please carry out the following
steps:
1.
Set the attenuation coefficient of the probe in the menu as 10X and that of the
switch in the probe as 10X
(see "
How to Set the Probe Attenuation Coefficient
on P14), and connect the probe with the CH1 channel. If a probe hook tip is used,
ensure that it keeps in close touch with the probe. Connect the probe tip with the
signal connector of the probe compensator and connect the reference wire clamp
with the ground wire connector of the probe connector, and then press the button
"Autoset".
2.
Check the displayed waveforms and regulate the probe till a correct
compensation is achieved (see
and
13
