5.Advanced User Guidebook
Pass/Fail test:
Detect whether the input signal is within the limits of the rule, if it exceeds limits of the
rule, it is "Fail"; otherwise it is "Pass". Also it can output fail or pass signal by built-in and
configurable output port. To run the test, read the following steps:
1.
Press
Utility
button, then
H1
button, turn the
M
knob to choose
Pass/fail
menu option,
Pass/Fail menu will be displayed in the bottom.
2.
Enable switch on
: Press
H2
button to show
Operate
menu, then, press
F1
button to
set
Enable
as
ON
.
3.
Create rule
: Press
H4
button to enter
Rule
setting menu. Press
F1
button to choose
the source; Press
F2
button, turn the
M
knob to set Horizontal tolerance; Press
F3
button, turn the
M
knob to set Vertical tolerance; Press
F4
button to create the rule.
4.
Set output type
: Press
H3
button to enter
Output
option setting. Choose any one or
two of the options "
Pass
", "
Fail
" or "
Beep
". "
Pass
" and "
Fail
" are mutually exclusive
options, which could not be chosen simultaneously. "
Stop
" means stop once the
condition satisfies your setting.
5.
Begin to test:
Press
H2
button, then
F2
button to select "
Start
", the test will begin.
6.
Save rule:
Press
H5
button, then
F2
button to save the rules, which could be called up
at once when need, press
F3
button to call up the rule saved.
Figure 5-45 Pass/Fail test
Note:
1.
When Pass/Fail is ON, if XY or FFT is ready to run, then Pass/Fail will be closed;
under the mode of XY or FFT, Pass/Fail is unable.
2.
Under the mode of Factory, Auto Scale and Auto Set, Pass/Fail will be closed.
3.
When no save setting left in the rule save, tip will be given to show "NO RULE
SAVED".
4.
Under the status of stop, data comparing will stop, and when it goes on running, the
number of Pass/Fail will increase from the former number, not from zero.
5.
When the waveform playback mode is on, Pass/Fail is used to test the played-back
waveform specially.
56
