![background image](/i/parrot/43663/parrot-asteroid-smart/h/parrot-asteroid-smart-013.png)
English 13
13
English
local car audio specialist.
Note : Make sure you also supply power to your
antenna if it is amplified. Power to the antenna
can be supplied using the Parrot ASTEROID
Smart ISO cable.
Installation using the holder
1. Loosen the 4 screws to remove the Parrot
ASTEROID Smart holder.
2. Insert the holder into the dashboard. To do
so, bend the tabs 90 degrees (diagram A p.7)
3. Install the Parrot ASTEROID Smart and
fasten the screws (diagram B p.7).
4. Attach the trim ring (diagram C p.8).
Installation using the side screw holes
1. Loosen the 4 screws to remove the Parrot
ASTEROID Smart holder.
2. Remove the two side brackets (diagram D
p.8).
3. Position the Parrot ASTEROID Smart so
that its screw holes are aligned with the
screw holes of the bracket.
4. Tighten as many screws as necessary
depending on the model of your vehicle.
Only use the provided screws.
Installing the GPS receiver
Stick the GPS receiver in an unobstructed area
inside the car.
Athermic windshields and windows with a
built-in antenna can interfere with GPS
reception and reduce the reliability of
information from navigation applications.
The GPS receiver antenna is located
on the side where "Parrot
ASTEROID GPS" is written and
where the star-shaped logo is. This
logo must always be directed
towards the sky.
If your vehicle has an athermic windshield, stick
the GPS receiver on the windshield on the non
athermic area. The side where the star-shaped
logo is must be stuck on the windshield
(diagram F p.9).
Note : The non athermic area of the windshield
depends on the model of your vehicle. It is
usually located near the rear view mirror.
If your vehicle does not have an athermic
windshield, stick the GPS receiver on the
dashboard. The side where the star-shaped
logo is must be visible (diagram E p.9).
To make sure the adhesive tape adheres well :
use the provided adhesive tape ;
clean the area with an appropriate cleaning
product before sticking the support ;
once you have stuck the support on the
dashboard, wait for approximately 2 hours
without handling it.
Connecting the parking brake lead
The parking brake lead allows you to use the
Parrot ASTEROID Smart video function or
applications only when the parking brake is set.
If this cable is not connected to your vehicle
parking brake system, the video function will
not be available.
1. Connect the parking brake extension lead
to the Parrot ASTEROID Smart green
cable.
2. Locate and test the parking brake signal
cable in the vehicle. This cable connects
your parking brake to the parking brake
signal on your dashboard.
3. Route the Parrot ASTEROID Smart parking
brake extension lead (green) safely and
securely from the Parrot ASTEROID Smart
and connect this to the parking brake signal
cable using a suitable method.