44
Getting Started
2
Attaching a Lens
Attach a Q-mount lens to the camera’s body.
The steps will be described here using a 01 STANDARD PRIME lens.
1
Make sure that the camera is turned off.
2
Remove the body mount cover (
1
)
and lens mount cover (
2
).
Be sure to put the lens down with the lens
mount side facing upward to protect
the lens mount from damage.
3
Align the lens mount index (red
dots:
3
) on the camera and the
lens, and secure by turning the lens
clockwise until it clicks.
After attaching, turn the lens
counterclockwise to check that
the lens is locked in place.
• When attaching/removing the lens, choose an environment that is relatively
free of dirt and dust.
• Keep the body mount cover on the camera when a lens is not attached.
• Be sure to attach the lens mount cover and lens cap to the lens after
removing it.
• Do not insert any fingers into the camera mount or touch the CMOS sensor.
• The camera body and lens mount incorporate lens information contacts. Dirt,
dust, or corrosion may damage the electrical system. Please contact
a PENTAX Service Center for professional cleaning.
• We assume no responsibility nor liability for accidents, damages and
malfunctions resulting from the use of lenses made by other manufacturers.
3
e_kb535_ENG.book Page 44 Wednesday, October 10, 2012 3:03 PM