[Страница 8/29] - Руководство: автомобильная аудиосистема PHILIPS CMD310

Инструкция для PHILIPS CMD310

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

3 Before use

Caution

•

Use the controls only as stated in this user manual.

Always follow the instructions in this chapter in

sequence.

If you contact the Consumer Care, you will

be asked for the model and serial number of

this apparatus. The model number and serial

number are on its bottom. Write the numbers

here:

Model No.: __________________________

Serial No.: ___________________________

Install the car audio system

These instructions are for a typical installation.

However, if your car has different requirements,

make the adjustment accordingly. If you have

any question regarding installation kits, consult

your local retailer.

Caution

•

This system is designed for negative ground (earth) 12V

DC operation only.

•

Always install this system in the car dashboard. Other

locations can be dangerous as the rear of the system

heats up during use.

•

To avoid short-circuit: before you connect, make sure

that the ignition is off.

•

Make sure that you connect the yellow and red power

supply leads after all other leads are connected.

•

Make sure that all loose leads are insulated with electrical tape.

•

Make sure that the leads do not get caught under

screws iron parts that will move (e.g. seat rail).

•

Make sure that all ground (earth) leads are run to a

common ground (earth) point.

•

Use only the supplied mounting hardware for a safe

and secure installation.

•

Improper fuses can cause damage or fire. When you

need to change the fuse, consult a professional.

•

When you connect other devices to this system, make

sure that the rating of the car circuit is higher than the

total fuse value of all the connected devices.

•

Never connect speaker wires to the metal body or chassis

of the car.

•

Never connect speaker wires with stripes to one another.

Connect wires

The ISO male connectors are not supplied.

Caution

•

Make sure that all loose leads are insulated with

electrical tape.

Check the car’s wiring carefully and

connect them to the ISO male connectors.

Connector

Connect to

1 Yellow wire

The +12V car battery

which is live at all times

2 Blue/White wire The electric antenna

control lead or power

supply lead of the

antenna booster. If there

is no electric antenna

or antenna booster, or

it is manually operated

telescopic antenna, it is

unnecessary to connect

this lead.

3 Black wire

A metal surface of the

car. Connect the black

ground (earth) lead

before connecting the

yellow and red power

supply leads.

a
b
c
d

Оглавление инструкции

Страница 1 из 30
Always there to help you Register your product and get support at www.philips.com/welcome Vragen? Vraag het Philips User manual CMD310
Страница 2 из 30
Contents 9 Use the dock 18 18 18 18 19 20 20 20 20 20 21 10 Adjust sound 12 12 12 12 12 13 13 22 22 22 22 22 22 22 22 22 11 Adjust system settings 23 12 Additional information 15 15 15 15 24 24 24 13 Product information 25 14 Troubleshooting 26 26 26 15 Glossary 27 1 Important 3 3 3
Страница 3 из 30
1 Important • • Safety Read and understand all instructions before you use the device. If damage is caused by failure to follow instructions, the warranty does not apply. • Modification of the product could result in hazardous radiation of EMC or other unsafe operation. • The device is designed for
Страница 4 из 30
Please act according to your local rules and do not dispose of your old products with your normal household waste. Correct disposal of your old product helps to prevent potential negative consequences for the environment and human health. Environmental information All unnecessary packaging has been
Страница 5 из 30
2 Your car audio system Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With this system, you can: • enjoy audio from USB storage devices, iPhone, iPod touch, and other
Страница 6 из 30
Overview of the system u t sr q p on a b c d ef jk ghi a b c • • e f • • • • • Tune to a radio station. Press to skip to the previous track. Press and hold to rewind a track. • Press to enable or disable the full sound. Press and hold to access the sound setting menu. • d Press to answer or redial
Страница 7 из 30
i • • • j • • k • • • In radio mode, press to select the preset radio station of No. 4. In radio mode, press and hold to store the current radio station at channel No. 4. For tracks, press to start playing all tracks in the current album or folder randomly. In radio mode, press to select the preset
Страница 8 из 30
3 Before use Connect wires The ISO male connectors are not supplied. Caution •• Use the controls only as stated in this user manual. Always follow the instructions in this chapter in sequence. If you contact the Consumer Care, you will be asked for the model and serial number of this apparatus. The
Страница 9 из 30
Connector Connect to Connector 4 Red wire 5 6 7 8 2 The +12V power terminal which is live in the accessory (ACC) position of the ignition switch. If there is no accessory position, connect to the +12V car battery terminal that is always live. Make sure that the black ground (earth) lead is
Страница 10 из 30
2 Make sure that the car dashboard opening is within these measurements: 4 Place the supplied rubber cushion over the end of the mounting bolt. 5 Slide the system into the sleeve until you hear a "click". 6 Attach the trim plate. 7 Reconnect the negative terminal of the car battery. m 5m mm 53mm
Страница 11 из 30
4 Get started 3 4 5 6 Rotate Press Rotate Press to set the hour. to confirm. to set the minute. to confirm. Turn on Set the clock format Press . »» [WELCOME] scrolls. 1 • To turn off the system, press and hold until [GOODBYE] is displayed. Change system settings 1 2 3 Press and hold menu. to access
Страница 12 из 30
5 Listen to radio Tune to a radio station 1 Select a radio region You can select a radio region that matches your location. 1 2 3 Press and hold menu. to access the system Rotate to select an option. • [USA] (United States) • [EUR] (Western Europe) • [RUS] (Russia) • [AUS] (Australia) • [EAS]
Страница 13 из 30
4 Repeat steps 2 and 3 to store more radio stations. • To replace a radio station, store another one in its channel. Tune to a preset station 1 2 Press repeatedly to select a band. Press a numeric key to select a preset station. Play with RDS Enable the RDS function Note •• The RDS function is
Страница 14 из 30
Use alternate frequencies If the signal of an RDS station is poor, enable the AF (Alternate Frequency) function to search for another station that transmits the same program. 1 2 3 Press and hold menu. Rotate to select a setting: • [AF ON]: Enable the AF function. • [AF OFF]: Disable the AF
Страница 15 из 30
6 Use Bluetooth devices With this car audio system, you can listen to audio from a player or make a call through Bluetooth. Tip •• You can also control the play on the Bluetooth device. Make a call Note Pair a device Note •• WOOX Innovations does not guarantee compatibility with all Bluetooth
Страница 16 из 30
7 Play from a USB storage device This system can play .mp3 and .wma files that are copied onto a compatible USB storage device. Control play During play, follow the instructions below to control play. Buttons Pause or resume play. / Note •• WOOX Innovations does not guarantee compatibility with all
Страница 17 из 30
8 Listen to an external device You can use the system to amplify the audio input that is transferred from an external device, for example, MP3 player. 1 2 3 17 Press repeatedly to switch the source to [MP3-LINK]. Connect the MP3 link cable to • the MP3-LINK socket on the system, and • the audio
Страница 18 из 30
9 Use the dock 2 Pull out the dock bracket until you hear a "click". An application CarStudio is available in the iTunes App Store for this car audio system. To enjoy full features, download the application to your iPhone or iPod touch. K CLIC Note •• If the CarStudio application is not installed,
Страница 19 из 30
1 2 Connect your iPhone or iPod touch to the dock with its screen facing you. »» The system switches the source to [iPHONE] automatically. If not, press repeatedly to switch the source. 1 Turn the dock bracket anti-clockwise by 90 degrees. 2 Adjust the viewing angle. Pinch the hooks to secure your
Страница 20 из 30
Pair your iPhone via Bluetooth Note •• To use the hands-free function, pair your iPhone with the car audio system via Bluetooth first. •• Make sure that the Bluetooth feature is enabled on your iPhone. For an iPhone using iOS 4.X or under • Manually complete the pairing. (Refer to "Use Bluetooth
Страница 21 из 30
1 Press and hold RELEASE to loosen the hooks. K CLIC 2 2 Push the dock panel inwards until you hear a "click". Pull out your iPhone or iPod touch. CLICK 3 Tip •• For the safety of your property, undock your iPhone or iPod touch before leaving your car. Store the dock bracket Note •• Before storage,
Страница 22 из 30
10 Adjust sound The following operations are applicable to all compatible media. Adjust the volume level Rotate clockwise or anti-clockwise. Mute sound Press . • To restore sound, press Enable the full-range sound Press repeatedly to select one of the following settings. • [FULL ON]: Enable the
Страница 23 из 30
11 Adjust system settings 1 2 3 Press and hold menu. Press repeatedly until one of the following settings is displayed. • [BEEP], [BKO], [DIMMER], or [DEMO] Rotate [BEEP] [BKO] [DIMMER] [DEMO] 23 to access the system EN to change the setting. [BEEP ON] [BEEP OFF] [BKO 10S] Enable the beep sound of
Страница 24 из 30
12 Additional information Reset the system You can reset the system to factory default settings. Note •• If the new fuse gets damaged again, there may be an internal malfunction. Consult your dealer.. 1 2 Open the protective cover for the USB socket, MP3-LINK socket, and RESET button. Press RESET
Страница 25 из 30
13 Product information Note •• Product information is subject to change without prior notice. Power supply 12 V DC (11V - 16V), negative ground Fuse Suitable speaker impedance Maximum power output Continuous power output 15 A 4-8 50 W x 4 channels 22 W x 4 RMS (4 10% T.H.D.) Pre-Amp output voltage
Страница 26 из 30
14 Troubleshooting Warning •• Never remove the casing of this product. To keep the warranty valid, never try to repair the product yourself. If you encounter problems when using this product, check the following points before requesting service. If the problem remains unsolved, go to the Philips
Страница 27 из 30
15 Glossary M MP3 A file format with a sound data compression system. MP3 is the abbreviation of Motion Picture Experts Group 1 (or MPEG-1) Audio Layer 3. W WMA (Windows Media Audio) An audio format owned by Microsoft, is a part of Microsoft Windows Media technology. Includes Microsoft Digital
Страница 28 из 30
EN 28
Страница 29 из 30
2014 © WOOX Innovations Limited. All rights reserved. Philips and the Philips’ Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used by WOOX Innovations Limited under license from Koninklijke Philips N.V. CMD310_12_UM_V3.0
Страница 30 из 30

Инструкция для PHILIPS CMD310

Инструкции и руководства похожие на PHILIPS CMD310

Другие инструкции и руководства из категории автомобильная аудиосистема