![background image](/i/philips/154143/philips-cmd310/h/philips-cmd310-009.png)
9
EN
Connector
Connect to
4 Red wire
The +12V power
terminal which is live in
the accessory (ACC)
position of the ignition
switch. If there is no
accessory position,
connect to the +12V
car battery terminal that
is always live. Make sure
that the black ground
(earth) lead is connected
to a metal surface of the
car first.
5 Green and green/
black wires
Left speaker (rear)
6 White and white/
black wires
Left speaker (front)
7 Gray and gray/
black wires
Right speaker (front)
8 Purple and
purple/black
wires
Right speaker (rear)
2
Connect the other end of the standard
connector to the car audio system.
a
b
c
d
e
f
g
h
Connector
Connect to
1
ANTENNA
Antenna for radio
2
External Mic
An external
microphone for
phone call
3
SUBWOOFER
(Socket)
Subwoofer
4
REAR LINE OUT L
(Socket)
Rear left speaker
5
REAR LINE OUT R
(Socket)
Rear right speaker
6
OE REMOTE
(Brown) OE remote
7
FRONT LINE OUT L
Front left speaker
8
FRONT LINE OUT R
Front right speaker
Tip
•
The pin arrangement for the ISO connectors depends
on the type of vehicle you drive. Be sure to make
proper connections to prevent damage to the system.
Mount into the dashboard
1
If the car does not have an on-board drive
or navigation computer, disconnect the
negative terminal of the car battery.
•
If you disconnect the car battery in
a car that has an on-board drive or
navigation computer, the computer
may lose its memory.
•
If the car battery is not disconnected,
to avoid short-circuit, make sure that
the bare wires do not touch each
other.