![background image](/i/president/155450/president-pm-2010-wp/h/president-pm-2010-wp-055.png)
55
ATIS
This function is the Automatic Transmitter Identification Sys-
tem. The Atis signal shall be transmitted at the end of each
transmission. The ATIS ID is composed by number of 10 dig-
its, and it is already registered to your radio. The first digit is
pre-selected to “9”, but it doesn’t appear on the display. From
2
nd
to last digits are displayed. If it’s necessary to change the
ATIS or program the private channel, the user should send
back to distributor for reprogramming.
ATIS Verification
1.
Push and hold
MEM
for 1.5 sec-
onds, the radio will change to ATIS
confirmation mode.
“ALERT”
and 1st
digit start to blink.
Note:
If ATIS is not programmed yet, the radio is not able to
change to ATIS confirmation mode.
2.
Push
MEM
to check next digit.
3.
Repeat step 2 to 9th digit.
4.
Push and hold
MEM
for 1.5 sec-
onds to exit the verification mode.
Note:
Push
SCAN
to return to step 1
(for checking to once more). Push
16/9
to exit verification mode
and change to EMG 16CH mode.
UIC (for the authorized country only)
This feature can change the following 3 modes of operation;
USA, INT ans CAN. This feature is enabled when user is push-
ing and holding
LOCK
and
16/9
keys and turns on the radio.
“INT” appears on the display
.
Push and hold
TRI
key to UIC
change.