GB

23

Precautions When Using Audio
Cassettes

Before Contacting the After-Sales
Service

Check that the tape in the cassette is sufficiently taught.

To prevent erasing a cassette that you wish to keep, remove the safety
tab on the upper edge of the cassette. To record a cassette, where  the
tab has been broken, simply cover the opening with adhesive tape.

When you have finished playing a cassette, always put it back in its case.

Store your cassettes in a clean place, out of direct sunlight, where
they will not be exposed to high temperatures.

Avoid using 120-minute cassettes as they place unnecessary strain
on the tape mechanism.

It always takes a little time to become familiar with a new appliance. If you
have any of the problems listed below, try the solutions given. They may
save you the time and inconvenience of an unnecessary service call.

If the above guidelines do not allow you to solve the problem, take a note of:

The model and serial numbers, normally printed on the rear of the system

Your warranty details

A clear description of the problem

Then contact your local dealer or SAMSUNG after-sales service.

Problem

The system does not work

There is no sound

The Timer does not work

System still doesn’t work, even after fol-

lowing steps above.

The compact disc player does not
start playing

The tape does not start playing

The volume falls off

The cassette is not erased correctly
There is excessive wow and flutter

Reception is poor or no radio sta-
tions are received at all

G

E
N
E
R
A
L

C

D

R
A
D

I

O

C
A
S
S
E

T
T
E
S

Checks/Explanation

• The main lead is not correctly plugged into a

wall socket or the wall socket is not switched on.

• The remote control batteries need replacing or

the polarity has not been respected.

• The  Standby/On button has not been pressed.

• The volume has been completely turned down.
• The correct function (TUNER, CD, TAPE,

AUX) has not been selected.

• You have connected a set of earphones.
• The loudspeaker wires have been disconnected.
• The MUTE button has been pressed.

• The timer has been stopped by pressing

TIMER ON/OFF.

•

Press the S.Bass  button for 5 seconds in

power ‘OFF’(standby), the system is

returned the original position (RESET)

• The CD function has not been selected.
• The disc has been inserted face down or is

either dirty or scratched.

• The laser sensor is dirty or dusty.
• The system has not been installed on a flat,

horizontal surface.

• Condensation has formed in the player; leave

the system in a warm, airy room for at least
one hour.

• The TAPE function has not been selected.
• The cassette has not been inserted correctly.
• The cassette player has not been closed.
• The tape is either slack or broken.

• The audio heads are dirty.
• The rollers or drive capstans are dirty.
• The tape is worn.

• The TUNER function has not been selected.
• The radio frequency has not been correctly

selected.

• The aerial has been disconnected or is not fac-

ing the right way. Turn it until you find the best
orientation.

• You are in a building that blocks radio waves;

you must use an outside aerial.