![background image](/i/sinbo/134050/sinbo-ssi-2869/h/sinbo-ssi-2869-010.png)
- 9 -
Simple Repair Methods
Problem
Possible Reasons
Measurement
Not enough heat or Too
heat
Rotate thermostat dial improperly
or unplugging
Correct Thermostat dial in position
and check if the iron is plugged.
No steam or Leakage
The thermostat dial has been set to
MIN
Set the thermostat dial to the
required position.
No burst of steam or no
vertical steam
The (vertical) burst of steam
function has been used too often
within a very short period. The iron
is not hot enough
Continue ironing in horizontal
position and wait a while before
using the (vertical) burst of steam
function again
Leaking water from
Soleplate
Set the thermostat dial out of steam
range.
Set the thermostat dial as per steam
range.
The heat is still not enough.
Open steam control button only after
the indicator light goes off.
The water is over than max position Pour out the remaining water
Little Steam
Check if the steam control button
is in proper location.
Set the steam control button to the
proper location.
Steam hole is blocked.
Clean hole with distilled water.
Too little water in the water tank
Fill water into the box
No Spraying
No enough pressure or air inside
Press the spray nozzle by hand,
and push the spray button several
times continuously.