Instruction manual

Utilization of the product

If you want to dispose of this product, do not 

mix it with general household waste. There is a 
separate collection system for used electronic 
products in accordance with legislation that 
requires proper treatment, recovery and 
recycling.

Please contact your local authorities for 

the correct method of disposal. By doing so, 
you will ensure that your disposed product 
undergoes the necessary treatment, recovery 
and recycling and thus prevent potential 
negative effects on the environment and 
human health.

Important safeguards

•  The instruction manual contains important 

operating and maintenance instructions. For 
your safety, it is necessary to refer to the 
manual. Keep the manual for future use.

•  Do not hit or drop the unit.
•  Do not expose the unit to vibration, direct 

sunlight, too high or low temperatures or 
humidity.

•  Do not disassemble the unit yourselves. 

Refer servicing to qualified service personnel

All the illustrations in this manual are 

schematic images, which may differ from 
actual objects.

Power supply

Battery operation

•  Open the battery compartment cover.
•  Insert 6 x UM-2/LR14 batteries. Please 

observe correct battery polarities or the set will 
not work.

•  Close the battery compartment cover.

  This unit has a battery saver function. 

3

If you wish to preserve the batter life use the 
switch (#20). The unit will not use the battery 
power which will enhance battery life. Please 
note that in this mode time settings and radio 
presets will be lost.

AC operation

•  Before the first connecting of the appliance 

check that voltage indicated on the rating label 
corresponds the mains voltage in your home.

•  Plug the corresponding end of cord into 

the AC socket on the rear of the set.

•  Insert the plug into power supply.

Caution: 

•  When the set is only used with AC or is 

not used for 2 weeks or more, please remove 
the batteries, to avoid damage to the set from 
leakage of batteries. 

•  Always switch off the unit when not in use.
•  Always unplug the appliance from power 

supply, when not using the device for a long 
time.

General operations 

Digital clock

This unit has a built-in digital clock which is 

displayed when the set is in the standy mode.

•  Switch the unit to standby mode.
•  Press and hold CLOCK SET, the display 

will show blinking 12 or 24 hour indications.

•  Press TUNE+/- to choose and press 

CLOCK SET to confirm your selection. 

•  Press TUNE+/- repeatedly to set correct 

hour, confirm by pressing CLOCK SET. Follow 
the same procedure for minute setting.

Electronic volume control

•  This unit uses an electronic volume control. 

To increase or decrease the loudness of unit, 
press respectively VOLUME UP/VOLUME 
DOWN buttons.