4

Instruction manual

Radio operation

•  Press the ON/STANDBY button to switch 

the unit on.

•  Press the FUNCTION button repeatedly 

until the display shows FM. 

•  To improve radio reception, adjust the unit 

position. To further enhance reception, extend 
the telescopic antenna found at the rear of the 
unit.

•  After tuning into a desired station, use FM 

MODE button to select MONO/STEREO mode. 
In cases of poor reception we recommend to 
use the MONO mode for better sound clarity.

Automatic scan and store 

•  Press and hold FM MODE, the unit will 

automatically scan all stations and store the 
first 30 found stations into the memory presets.

Manual frequency adjustment 

•  Press and quickly release the TUNE+ or 

TUNE- buttons to manually adjust the radio 
frequency one step at a time.

•  When the desired station is found, it can 

be saved into one of the MEMORY positions.

See “Radio memory” section for further 

details.

Automatic frequency adjustment 

•  Press and hold the TUNE+ or TUNE- 

buttons to automatically seek the next available 
radio frequency.

•  When the desired station is found, it can 

be saved into one of the MEMORY positions.

See “Radio memory” section for further 

details.

Radio memory 

•  After tuning into a desired station, it can 

be stored into one of the 30 available memory 
positions.

•  Short press the MEM./PROG. button to go 

to memory setting mode.

•  Press and release the MEM UP button to 

choose the desired memory storage position 

4

you would like to store into (up to 30).
   •  Short press MEM./PROG. again to confirm 
selection. The display will stop flashing.

Recalling a saved memory station 

•  Press MEM UP button to find a saved 

memory position.

•  To erase a saved radio station, simply 

replace it with a new station in the same 
memory position.

Compact disc operations

Insertion and removal of discs

•  When opening the CD-door, always 

ensure the disc is not in motion (not spinning) 
when you open the CD-door. Always press 
STOP button to stop the disc spinning first.

•  Place a CD into the compartment with the 

label-side (printed side of disc) facing upwards. 
Press down in the center part of disc until the 
disc “locks” onto the center spindle.

•  When the CD has been placed onto the 

center spindle, gently lower the CD-door 
downwards until it locks shut. The CD is now 
ready to be played.

•  To remove a disc, follow the same 

procedure as described above, except to 
remove the CD instead of inserting it into the 
compartment, by placing one finger at the 
middle of disc (center spindle) & the other at 
the edge of the disc & gently pulling upwards.

  Please make sure to always fold down 

the handle before opening the CD door.

•  Press CD button to enter CD mode. 
•  Put a disc into the CD compartment and 

close the CD door.

•  The display will indicate “READ” for a few 

seconds and then start to play the first track.

•  The display will indicate the current track 

number and playback time.

General operation

•  Set FUNCTION switch to CD position.
•  Put a disc into the CD compartment and