![background image](/i/yamaha/160483/yamaha-xjr1300-l-1999/h/yamaha-xjr1300-l-1999-051.png)
2-29
E Fasten the high tension cables
(#1, 2) with a plastic clamp. Posi-
tion the clamp at 50 – 80 mm
above the high tension cable
number.
F Fasten the horn lead to the frame
with a plastic band. Make sure
that the end of band down ward.
G Install the frame ground and ig-
niter unit together with screw.
A Insert the plastic band through
the hole of plastic panel and then
fasten the clutch hose with it.
Make sure that the end of band
inside of motorcycle.
B To headlight lower hole.
C Route the wireharness and start-
er cable through the guide.
D Connect the ignition lead with
white marking tape to the ignition
coil (#1, 4).
1
Clutch hose
2
Starter cable
3
Air filter case drain hose
4 Frame ground
5
Flasher relay connector
6
Oil light relay connector
7
Igniter unit connectors
8
Starter motor
9
AC generator
10
Sidestand switch
11
Sidestand switch lead
12
Ignition coil lead (#1, 4)
SPEC
CABLE ROUTING