![background image](/i/zelmer/155654/zelmer-23z052/h/zelmer-23z052-069.png)
69
GW23-011_v01
The humidifier is equipped with a normal/micro mist
function.
With the micro mist setting, the humidifier filters out large
mist particles and emits only fine mist into the room.
To set the micro mist function, rotate the inner bottom of
nozzles
(2)
counter-clockwise.
To set the normal mist function, rotate the inner bottom of
nozzles
(2)
clockwise.
To operate the appliance
NOTE: You will hear a beep each time you press a button.
Plug in the appliance
1.
POWER
button
(K)
Press the
POWER
button
(K)
to switch on the appliance. Mist will start coming out
from the nozzles
(2)
. After switching on, the appliance will operate in the auto mode
and in the warm mist mode.
NOTE: Wait for about 2–3 minutes so that water from the water tank (5) pours
onto the base (6).
2. Desired humidity button
(L)
Smaller figures are displayed above the room humidity indicator
(G)
which indicates
the desired humidity level
(F)
. Press the
DESIRED (L)
button to change the settings
in the following order:
40%, 45%, 50%, 55%, 60%, 65%, 70%, 75%, continuous (Co).
Operating instructions
Preparing for operation
1. Remove the water tank
(5)
from the appliance using the attached handle.
2. Remove the mist nozzle
(2)
from the water tank
(5)
.
3. Turn the water tank
(5)
upside down and remove the water tank cap by turning it
counter-clockwise.
NOTE: The Nano-Silver water filter is attached to the water tank cap. If you do
not wish to use the filter, it can be removed by turning it counter-clockwise (see
Replacing the Nano-Silver water filter page 71). Place the removed Nano-Silver
filter into a plastic bag and put in the carton for safe keeping.
4. Pour clean water into the water tank
(5)
(DO NOT OVERFILL). Secure the water
tank cap back on by turning it clockwise.
5. Place the water tank
(5)
back to the appliance by putting it on the base
(6)
of the
humidifier.
NOTE: When moving the humidifier always hold and
move by the base (6).
Mist nozzles (2)
The humidifier is equipped with two 360º direction free 2-way
nozzles
(2)
. Adjust each nozzle
(2)
to the desired direction.
Normal mist
Micro mist