4

GB

Connecting the supply cable to the mains

Install a standardised plug corresponding to the load
indicated on the data plate (

see side).

The appliance must be directly connected to the
mains using an omnipolar circuit-breaker with a
minimum contact opening of 3 mm installed between
the appliance and the mains, suitable for the load
indicated and complying with current electrical
regulations (the earthing wire must not be interrupted
by the circuit-breaker). The supply cable must not
come into contact with surfaces with temperatures
higher than 50°C.

!

 The installer must ensure that the correct electrical

connection has been made and that it is compliant
with safety regulations.

Before connecting to the power supply, make sure
that:

• The appliance is earthed and the plug is compliant

with the law.

• The socket can withstand the maximum power of

the appliance, which is indicated on the data plate
(

see below).

• The voltage must be in the range between the

values indicated on the data plate (

see below).

• The socket is compatible with the plug of the

appliance. If the socket is incompatible with the
plug, ask an authorised technician to replace it. Do
not use extension cords or multiple sockets.

!

 Once the appliance has been installed, the power

supply cable and the electrical socket must be easily
accessible.

!

 The cable must not be bent or compressed.

!

 The cable must be checked regularly and replaced

by authorised technicians only (

see Assistance).

!

The manufacturer declines any liability should

these safety measures not be observed.

DATA PLATE 

Dimensions 

width 43.5 cm 

height 32 cm 

depth 41,5 cm 

Volume 

lt. 58 

Electrical 
connections 

voltage: 230V/400V~ 3N 50/60Hz or 

50Hz  (see data plate) 
maximum power absorbed 10800W 

or 10700W  (see data plate) 

ENERGY LABEL 

Directive 2002/40/EC on the label of 

electric ovens. 
Standard EN 50304 

Energy consumption for Natural 

convection – heating mode:       /  

Convection mode. 

Declared energy consumption for 

Forced convection Class – heating 

mode:             /             Baking. 

This appliance conforms to the 

following European Economic 

Community directives:  

2006/95/EEC of 12/12/06 (Low 
Voltage) and subsequent 

amendments; 

- 2004/108/EEC of 15/12/04 

(Electromagnetic Compatibility)  and 

subsequent amendments; 

- 93/68/EEC of 22/07/93 and 

subsequent amendments. 

- 2002/96/EC and subsequent 

amendments. 

Assistance

Communicating:

• appliance model (Mod.)
• serial number (S/N)
This information is found on the data plate located on the appliance and/or on the packaging.