21
Basic Operation
PIP (Picture-In-Picture)/POP (Picture-On-Picture)
functions
Q
Press the PIP button to enable the PIP function.
1.For PIP purposes, there are two groups of inputs classfied according to their
display modes:
Video Group: Video, S-Video and Component Y/C
B
/C
R
inputs
Graphic Group: HDTV input and Computer input.
2. The PIP function allows the projector to display one input from the Graphic
Group within one input from the Video Group, or display one input from Video
Group within one input from the Graphic Group.
3. Press the PIP button to switch to the main window or turn off the PIP function.
4. Select the input source for the main window by pressing the INPUT button.
Q
Press the POP key to enable the POP function.
Q
Press the ACTIVE button to switch to the active window. You can change the input signal setting in the active
window.
Q
Press + or - to adjust the size of the PIP window.
Q
Adjust the position of the PIP window with the ARROW keys (
c
/
e
/
d
/
f
).
Q
SCREEN
c
/
d
: Control the screen up or down directly. These functions are only available for BENQ's
accessory screen.
Turning the Power Off
Follow the steps below.
1.
Press the OFF key on the remote control or the POWER key
on the projector.
2.
The POWER light flashes green and the fans run for two
minutes to cool the lamp. The projector will not respond to
any commands until the cooling process is complete.
3.
Then, the POWER light is a steady orange once the cooling
process has finished. The fans will continue to run for about
two minutes after the light changes to orange.
4.
The fans stop and the light is orange.
5.
If the projector will not be used for an extended period, turn
the main power switch off and unplug the power cord from
the power outlet.
