![background image](/i/bombardier/149806/can-am-can-am-ds-90-2011-can-am-ds-70-2011-can-am-ds-90-x-2011-ds-70-2011/h/can-am-can-am-ds-90-2011-can-am-ds-70-2011-can-am-ds-90-x-2011-ds-70-2011-097.png)
MAINTENANCE PROCEDURES
Battery Removal
CAUTION Always respect this
order for disassembly; disconnect
BLACK (-) cable first.
Disconnect BLACK (-) cable first, then
RED (+) cable.
vmo2008-008-017_b
1. BLACK (-)
2. RED (+)
Remove battery from vehicle.
Battery Cleaning
Clean battery, battery casing, cables
and battery posts using a solution of
baking soda and water.
Remove corrosion from battery cable
terminals and battery posts using a
firm wire brush. Battery top should
be cleaned using a soft brush and any
grease-cutting soap or baking soda so-
lution.
Apply DIELECTRIC GREASE (P/N 293
550 004) or an equivalent on battery
posts to protect against oxidation.
Battery Installation
Reinstall battery in vehicle.
NOTICE
Always reconnect RED (+)
cable first, then the BLACK (-) cable.
Fuse
Fuse Replacement
NOTICE
Do not use a higher rated
fuse as this can cause severe electri-
cal system component damage.
The electrical system is protected by a
single 15 amp fuse.
If the fuse is open circuit (or burnt), re-
place it with a fuse of the same rating.
An in-line fuse holder is located on the
RED (+) battery cable.
vmo2008-008-017_a
1. Fuse holder
To replace the fuse, slightly press the
2 halves of the fuse holder together as
you twist them in a counterclockwise
direction.
Lights
Daytime Running Light Bulb
Replacement
DS 70 and DS 90
CAUTION Always turn the ig-
nition switch to the OFF position
before replacing a defective bulb.
Always check light operation after re-
placement.
_______________
95